Mechanical Engineering Department
Drawing Sheet - 3 (Projections of Points)
1. A point P is 30 mm above HP and 40 mm in front of VP. Draw its projections.
2. A point Q is 25 mm above HP and 30 mm behind VP. Draw its projections.
3. A point R is 35 mm below HP and 40 mm behind VP. Draw its projections.
4. A point S is 30 mm below HP and 40 mm in front of VP. Draw its projections.
5. Draw the projections of a point A, lying on the HP and 50 mm in front of the VP.
6. Draw the projections of a point B, lying 50 mm above the HP and on the VP.
7. Draw the projections of a point C, lying on the HP and 50 mm behind the VP.
8. Draw the projections of a point D, lying 50 mm below the HP and on the VP.
9. A point T is 20 mm above the ground and 30 mm behind VP. Draw its
projections.
10. A point T is 20 mm above the ground and 25 mm behind VP. Draw its
projections. The ground may be considered as 45 mm below the HP.
Engg. Graphics and Design Lab Projections of Points -1 -
Mechanical Engineering Department
Drawing Sheet - 3 (Projections of Points)
Problem-1
A point P is 30 mm above HP and 40 mm in front of VP. Draw its projections.
Problem-2
A point Q is 25 mm above HP and 30 mm behind VP. Draw its projections.
Problem-3
A point R is 35 mm below HP and 40 mm behind VP. Draw its projections.
Engg. Graphics and Design Lab Projections of Points -2 -
Mechanical Engineering Department
Problem-4
A point S is 30 mm below HP and 40 mm in front of VP. Draw its projections.
Problem-5
Draw the projections of a point A, lying on the HP and 50 mm in front of the VP.
Problem-6
Draw the projections of a point B, lying 50 mm above the HP and on the VP.
Engg. Graphics and Design Lab Projections of Points -3 -
Mechanical Engineering Department
Problem-7
Draw the projections of a point C, lying on the HP and 50 mm behind the VP.
Problem-8
Draw the projections of a point D, lying 50 mm below the HP and on the VP.
Engg. Graphics and Design Lab Projections of Points -4 -
Mechanical Engineering Department
Problem-9
A point T is 20 mm above the ground and 30 mm behind VP. Draw its projections.
Problem-10
A point T is 20 mm above the ground and 25 mm behind VP. Draw its projections. The
ground may be considered as 45 mm below the HP.
Engg. Graphics and Design Lab Projections of Points -5 -
