Scribd
Upload
11 views

Patient Monitoring System Program

Uploaded by

TIRUPATHI Mounika
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
11 views

Patient Monitoring System Program

Uploaded by

TIRUPATHI Mounika
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 2

#include <LiquidCrystal.

h>
#include <TimerOne.h>
LiquidCrystal lcd(13, 12, 11, 10, 9, 8);

int val;
int tempPin = A0;// temperature Sensor Pin
int HBSensor = 4;// Sensor Pin
int HBCount = 0;
int HBCheck = 0;
int TimeinSec = 0;
int HBperMin = 0;
int HBStart = 2;
int HBStartCheck = 0;

void setup() {
// put your setup code here, to run once:
lcd.begin(20, 4);
pinMode(HBSensor, INPUT);
pinMode(HBStart, INPUT_PULLUP);
Timer1.initialize(800000);
Timer1.attachInterrupt( timerIsr );
lcd.clear();
lcd.setCursor(0,0);
lcd.print("Current HB : ");
lcd.setCursor(0,1);
lcd.print("Time in Sec : ");
lcd.setCursor(0,2);
lcd.print("HB per Min : 0.0");
lcd.setCursor(0,3);
lcd.print("Body Temp : ");

void loop() {

if(digitalRead(HBStart) == LOW){
//lcd.setCursor(0,3);
//lcd.print("HB Counting ..");
HBStartCheck = 1;}
if(HBStartCheck == 1)
{
if((digitalRead(HBSensor) == HIGH) && (HBCheck == 0))
{
HBCount = HBCount + 1;
HBCheck = 1;
lcd.setCursor(14,0);
lcd.print(HBCount);
lcd.print(" ");
}
if((digitalRead(HBSensor) == LOW) && (HBCheck == 1))
{
HBCheck = 0;
}
if(TimeinSec == 10)
{
HBperMin = HBCount * 6;
HBStartCheck = 0;
lcd.setCursor(14,2);
lcd.print(HBperMin);
lcd.print(" ");
//lcd.setCursor(0,3);
//lcd.print("Press Button again.");
HBCount = 0;
TimeinSec = 0;
}
}

val = analogRead(tempPin);
float mv = (val/1024.0)*5000;
float cel = mv/10;
lcd.setCursor(14,3);
lcd.print(cel);
lcd.print(" ");
delay(100);

void timerIsr()
{
if(HBStartCheck == 1)
{
TimeinSec = TimeinSec + 1;
lcd.setCursor(14,1);
lcd.print(TimeinSec);
lcd.print(" ");
}
}

You might also like