Throttle Body Removal/Installation
Do not insert your fingers into the installed throttle body
when you turn the ignition switch to ON (II) or while the
ignition switch is ON (II). If you do, you will seriously
injure your fingers if the throttle valve is activated.
1. Remove the air cleaner.
2. Remove the harness clamp (A).
3. Disconnect the throttle body connector (B), and
the EVAP canister purge valve connector (C).
4. Disconnect and plug the water bypass hoses (D),
the purge hose (E).
5. Remove the throttle body (F).
6. Remove the purge pipe (G), the water bypass
hoses, and the purge hose from the throttle body.
7. Install the parts in the reverse order of removal
with a new gasket (H), then refill the radiator
with engine coolant.
NOTE:
• If you replace or clean the throttle body,
go to Step 8 .
• If you did not replace or clean the
throttle body, this procedure is
complete.
• Align the marks (I) on the hose and
throttle body, then insert the hose. Make
sure the clamp (J) is positioned as
shown.
• Align the mark (K) on the hose as
shown, then insert the hose. Make sure
the clamp (L) is positioned as shown.
8. Connect the HDS to the data link connector (DLC) (A)
located under the driver's side of the dashboard.
9. Turn the ignition switch to ON (II).
10. Reset the ECM/PCM with the HDS.
11. Select the ETCS TEST in the INSPECTION MENU with
the HDS.
12. Select TP POSITION CHECK and clear the throttle
position (TP) learned value.
13. Turn the ignition switch to LOCK (0).
14. Turn the ignition switch to ON (II), and wait 2 seconds
without pressing the accelerator pedal.
15. Do the ECM/PCM idle learn procedure.
ECM/PCM Idle Learn Procedure
The idle learn procedure must be done so the ECM/PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:
• Replace the ECM/PCM.
• Reset the ECM/PCM.
• Update the ECM/PCM.
• Replace or clean the throttle body.
• When the engine or transmission is disassembled.
NOTE: Clearing the DTCs with the HDS does not require you to do the idle learn procedure.
Procedure
1. Make sure all electrical items (A/C, audio, lights, etc.) are off.
2. Reset the ECM/PCM with the HDS.
3. Turn the ignition switch to ON (II), and wait 2 seconds.
4. Start the engine. Hold the engine speed at 3,000 rpm (min −1 ) without load
5. (A/T in P or N, M/T in neutral)
6. until the radiator fan comes on, or until the engine coolant temperature reaches 90 °C
(194 °F).
7. Let the engine idle for about 5 minutes with the throttle fully closed.
NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.
8. Verify on the HDS data list that the idle learn procedure is complete.
