0% found this document useful (0 votes)
223 views3 pages

Amendment No. 3 February 2021 TO Is 10500: 2012 Drinking Water - Specification

Uploaded by

aayushi shukla
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
223 views3 pages

Amendment No. 3 February 2021 TO Is 10500: 2012 Drinking Water - Specification

Uploaded by

aayushi shukla
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Free Standard provided by BIS via BSB Edge Private Limited to ENVIRO LAB -

ALWAR([email protected]) 103.104.202.130 [for non-commercial use only].

AMENDMENT NO. 3 FEBRUARY 2021

TO

IS 10500 : 2012 DRINKING WATER — SPECIFICATION


( Second Revision )

[Page 2, Table 2, Sl. No. (xv), col 3] — Substitute ‘1.0’ for ‘0.5’.

(Page 2, Table 2, Notes) — Substitute the following for the existing Notes:
‘NOTES
1 Approved and validated international test methods from ISO/ APHA/ ASTM/ AOAC/ EPA/
EN may also be followed.
2 In case of dispute, methods given at column 5 and wherever indicated by ‘*’ shall be the
referee method.
3 It is recommended that the acceptable limit is to be implemented. Values in excess of those
mentioned under ‘acceptable’ render the water not suitable, but still may be tolerated in the
absence of an alternative source but up to the limits indicated under ‘permissible limit in the
absence of alternate source’ in col 4, above which the sources will have to be rejected.’

(Page 3, Table 3) — Insert the following new entry at the end:


Table 3
Sl Characteristic Requirement Permissible Limit Method of Test, Remarks
No. in the Absence of Ref to
(Acceptable
Alternate Source
Limit)
(1) (2) (3) (4) (5) (6)
xiii) Uranium, mg/l, Max 0.03 No relaxation IS 3025 (Part 65) —

(Page 3, Table 3, Notes) — Substitute the following for the existing:


‘NOTES
1 Approved and validated international test methods from ISO/ APHA/ ASTM/ AOAC/ EPA/
EN may also be followed.
2 In case of dispute, methods given at column 5 and wherever indicated by ‘*’ shall be the
referee method.

1
Free Standard provided by BIS via BSB Edge Private Limited to ENVIRO LAB -
ALWAR([email protected]) 103.104.202.130 [for non-commercial use only].

3 It is recommended that the acceptable limit is to be implemented. Values in excess of those


mentioned under ‘acceptable’ render the water not suitable, but still may be tolerated in the
absence of an alternative source but up to the limits indicated under ‘permissible limit in the
absence of alternate source’ in col 4, above which the sources will have to be rejected.’

(Page 5, clause 4.2.7) — Substitute the following for the existing clause:

‘4.2.7 MS2 phage are indicators of viral contamination in drinking water and
have been taken as representatives for presence of viruses for the purpose in this
standard. MS2 phage shall be absent in 1 litre of water when tested in accordance
with USEPA method 1601 or USEPA method 1602. In case of dispute, USEPA
method 1602 shall be the referee method.
NOTE (for guidance purpose only) — If MS2 phage are detected in the drinking water, the
virological examination is to be done by the Polymerase Chain Reaction (PCR) method as given
in Annex B or the USEPA method in Manual of Method for Virology Chapter 16, June 2001.
If viruses are detected, the cause must be determined by immediate further investigation by the
concerned authorities.’

(Page 5, clause 4.2.7) — Insert the following new clause:

‘4.2.8 The information given in clauses 4.2.1 to 4.2.6 is for guidance purposes
only.’

(Page 6, clause 4.3.10) — Substitute the following for the existing clause:

‘4.3.10 The drinking water is expected to be free from microscopic organisms


such as algae, zooplanktons, flagellates, parasites and toxin producing organisms.
An illustrative (and not exhaustive) list is given in Annex C for guidance.’

(Page 6, clause 4.3.10) — Insert the following after clause 4.3.10:

‘4.3.11 The information given in clauses 4.3.1 to 4.3.7 and 4.3.10 is for guidance
purposes only.’

(Page 6, clause 5) — Substitute the following for the existing clause:

‘5 SAMPLING
Representative samples of water shall be drawn as prescribed in IS 1622 and IS
3025 (Part 1). For bacteriological requirements, representative samples of water
shall be drawn as given in IS 15185.’

2
Free Standard provided by BIS via BSB Edge Private Limited to ENVIRO LAB -
ALWAR([email protected]) 103.104.202.130 [for non-commercial use only].

(Page 6, Annex A) — Insert the following new entries at appropriate places:

IS No. Title
3025 (Part 65) : Methods of sampling and test (physical and chemical) for
2014 water and waste water : Part 2 Application of inductively
coupled plasma mass spectrometry (ICP-MS) —
Determination of 62 elements
15185 : 2016 Water quality — Detection and enumeration of Escherichia
coli and coliform bacteria — Membrane filtration method
for water with low bacterial background flora (first revision)

(FAD 14)
Publication Unit, BIS, New Delhi, India

You might also like