FACULTY OF MECHANICAL ENGINEERING TECHNOLOGY (FTKM)
UNIVERSITI MALAYSIA PERLIS
SEM 1 2023/2024
MMK38202 DESIGN OF DIE & MOULD
LAB ASSIGNMENT 5
RUBRIC MARKS
PSYCHOMOTOR SKILLS
1 2 3 4 5 W T
P1: Use of the software to Able to use the software to Able to use the software to Able to use the software to Able to use the software to Able to use the software to design
design a shape. design a shape. Less than design a shape but with errors. design a shape but with some design a shape but with less a shape with little errors. More
Perception (5%) 30% of the shape are 30% − 50% of the shape are errors. 50% − 70% of the errors. 70% − 90% of the than 90% of the shape are
designed correctly. designed correctly. shape are designed correctly. shape are designed correctly. designed correctly. 1 0
P2: Inputs of design parameters Able to put some design Able to put in some design Able to put in most design Able to put in all design Able to put in all design
for materials in software and parameters as inputs in parameters as inputs in parameters as inputs in parameters as inputs in parameters as inputs in software
Set (5%) generate the results from software but with errors. software but with errors. software but with errors. software but with few errors. accurately. Analysis are
analysis. Analysis are generated Analysis are generated Analysis are generated Analysis are generated generated according to the
according to the question according to the question and according to the question and according to the question question and more than 90% of 1 0
and less than 30% of 30% − 50% of design 50% − 70% of design and 70% − 90% of design design parameters are key-in
design parameters are parameters are key-in correctly. parameters are key-in correctly. parameters are key-in correctly.
key-in correctly. correctly.
Discussion on simulation Able to interprete the Able to interprete the results Able to interprete the results Able to interprete the results Able to interprete the results from
with two parameter included. results from the simulation from the simulation with two from the simulation with one from the simulation with two the simulation with two
with one parameters parameters included parameters included and parameters included and parameters included and 1 0
included discussed discussed discussed and do a comparison
P3: Produce a design scheduled Able to produce a design Able to produce a design Able to produce a design Able to produce a design Able to produce a design
with the use of software. scheduled but with errors. scheduled but with errors. 30% scheduled but with some scheduled but with few scheduled accurately. More than
Guided response Less than 30% of the − 50% of the design are errors. 50% − 70% of the errors. 70% − 90% of the 90% of the design are correct. 1 0
(5%) design are correct. correct. design are correct. design are correct.
TOTAL 0
