0% found this document useful (0 votes)
15 views3 pages

Study of R-L-C Parallel Circuit

Uploaded by

manikdas031973
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
15 views3 pages

Study of R-L-C Parallel Circuit

Uploaded by

manikdas031973
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

Department of Electrical Engineering

Study of R-L-C parallel circuit


Objective: To measure the current across individual components, total circuit current & power
factor of R-L-C parallel circuit.

Theory:

The three are shown in fig. joined in parallel across an A.C. supply of rms voltage V.

Let
V=I*R
V = I.* XL, XL = 2ПfL
V = I.* XC, XC = 1/ 2Пfc

Its phase angle is Ø = tan -1 [ (XL – XC) / R]

Components under test:

Sl. Components Qty Type Range Make


No. under test
1

Instrument Required:

Sl. No. Instruments Qty Type Range Make


Required

1 Voltmeter

2 Ammeter

3 Variac

Page | 1
Department of Electrical Engineering

Precautions:

1. All the meters should be taken in proper range.


2. Before connecting the meter in the circuits check there zero setting.
3. The current, voltage are noted when values settle to a steady value.
4. All joints should be tightly connected.
5. Voltage should not exceed 210V.
6. Supply is switched OFF after the experiment is over.

Circuit Diagram:

Procedure:

1. The circuit is made in the circuit diagram.


2. The variac should be kept in zero voltage position, the AC supply is switched ON.
3. The applied voltage is varied using the variac & corresponding value of voltage & current are
noted.
4. The readings of various voltages are tabulated till rated voltage (210V) of components is
reached.
5. The steps should be taken at least three (3) times.

Observation Table:

Sl. No. Supply Current I(A) Current across Current across Current across
Voltage VS(V) Resister IR(I) Inductor IL(I) Capacitor IC(I)

Page | 2
Department of Electrical Engineering

Find out the value with Unit:

Resistance Inductor Capacitor Phase Angle Power


(R) (L) (C) (Ø) Factor(COSØ)

Conclusion:

Page | 3

You might also like