D
6.9 AFCI(Optional) 1.Close the DC switch on the inverter.As long as the input
6.9.
9.11 A
Arrc-F
-Faault Ci
Cirrcuit IIn
nterr
rruupter ((A
AFCI) than 140V,the inverter display will show the following inform
In accordance with the National Electrical Code R, Article 690.11, the inverter has a connection error,the inverter LED will turn red.
system for the recognition of electric arc detection and interruption. An electric arc If other information is displayed,please refer to Chapter 13.If
problems during the debugging process and cannot solve it,p
with a power of 300 W or greater must be interrupted by the AFCI within the time service.
specified by UL 1699B. A tripped AFCI can only be reset manually. You can deactivate 2.Close the circuit breaker or switch between the inverter an
the automatic arc fault detection and interruption (AFCI) via a communication product will start a countdown to the self-check,and after the self-ch
connected to the grid.
in "Installer" mode if you do not require the function. The 2011 edition of the National 3.In normal operation,the leaves of the inverter indicator win
Electrical Code R, Section 690.11 stipulates that newly installed PV systems attached to 4.Finish debugging.
a building must be fitted with a means of detecting and disconnecting serial electric
arcs (AFCI) on the PV side.
6.9.2 Danger iin
nformati on
Danger of fire from electric arc
Only test the AFCI for false tripping in the order described below.
Do not deactivate the AFCI permanently.
If an "Error 200" message is displayed, the buzzer alarms, an electric arc occurred in
the PV system. The AFCI has tripped and the inverter is in permanent shutdown.
The inverter has large electrical potential differences between its conductors. Arc
flashes can occur through air when high-voltage current flows. Do not work on the
product during operation.
When the inverter error 200, please follow the steps:
6.9.3 Operation ssttep
6.9.3.1 Tu
Turrn tth
he DC&A
DC CS
AC witch tto
Sw op o sition "
po O FF".
"O
Fig 6.21
Wait for the screen be off.
6.9.3.2 P
Peerform ttrroubleshooting o onn tth
he P
PVV ssy
yste m:
Check the PV strings' open circuit voltage is normal or not.
6.9.3.3 A
Affter tth
he ffa
ault iiss rre
ectified, rre
estart tth
he iin
n verter:
Turn the DC & AC Switch to position "ON".
Fig 6.22
29
