Equilibrium of A Rigid Body-Problemler-1
Equilibrium of A Rigid Body-Problemler-1
Solution-1
Problem 2. The member shown in figure is pin connected at A and rests against a smooth
support at B. Determine the horizontal and vertical components of reaction at the pin A.
Solution-2
Problem 3. When the 0.05-kg body is in the position shown, the linear spring is stretched 10
mm. Determine the force P required to break contact at C. Complete solutions for (a) including
the effect of the weight and (b) neglecting the weight.
Solution-3
Problem4. The woman exercises on the rowing machine. If she exerts a holding force of F=200
N on handle ABC, determine the horizontal and vertical components of reaction at pin C and
the force developed along the hydraulic cylinder BD on the handle.
Solution 4
Problem 5. To accommodate the rise and fall of the tide, a walkway from a pier to a float is
supported by two rollers as shown. If the mass center of the 300-kg walkway is at G, calculate
the tension T in the horizontal cable which is attached to the cleat and find the force under the
roller at A.
Solution 5.
Problem-6
Solution 6.
Problem-7
Solution 7.
Problem-8 Valfin açık ve valf yayının tamamen sıkışmış durumu için A ve B baskı silindirli bir
külbütör şekilde gösterilmektedir. Bu konumda, yay kuvveti 900N'dur. Külbütörden C kam
miline etkiyen kuvveti belirleyiniz. Ayrıca, külbütörün O miline etkiyen kuvvetin büyüklüğünü
hesaplayınız.
Solution 8.
Problem-9 During an engine test on the ground, a propeller thrust T = 3000 N is generated on
the 1800-kg airplane with mass center at G. The main wheels at B are locked and do not skid;
the small tail wheel at A has no brake. Compute the percent change n in the normal forces at A
and B as compared with their "engine-off" values.
Solution 9.
Problem-10 Determine the moment M which the motor must exert in order to position the
uniform slender bar of mass m and length L in the arbitrary position ɵ. The ratio of the radius
of the gear wheel B attachedto the bar to that of the gear wheel A attached to the motor shaft is
2.
Solution 10.
Problem-11 Hortum başının yaylı pistonunu açmak için B noktasında 35 N değerinde eksenel
bir kuvvet gerekmektedir. A noktasında kola uygulanması gereken F kuvveti ve O daki pime
etkiyen tepki kuvvetinin büyüklüğünü belirleyiniz. Pistonun B noktasında koldaki düşey olarak
genişletilmiş delikten geçtiğini, bu nedenle ihmal edilebilir bir düşey kuvvet ilettiğine dikkat
ediniz.
Solution 11.