Model Question Paper
The question paper consists of one hundred multiple choice objective type questions to
be answered on the OMR answer sheet using HB pencil in 2 hours. A few questions are
given as a model below. Note: Calculators are not allowed into the Examination Hall.
Candidates have to bring their own pencils and erasers.
1.The armature of a d.c machine is made of A B C D
(A) Silicon steel (B) Wrought iron (C) Cast steel (D) Soft
iron
2.The main drawbacks of d.c shunt generator is that A B C D
(A)Shunt circuit has high resistance (B) Generator voltage is
small (C) Terminal voltage drops considerably with load
(D) It is expensive
3.Transformers usually transfer electrical energy from primary A B C D
to secondary with change in
(A) Frequency (B) Voltage (C) Power (D) Time period
Syllabus for Written Test of AP Transco
Assistant Engineer (Telecom) 2011-12
Network Analysis : Kirchoff’s Laws, RC, RL & RLC Circuits, Initial conditions,
Energy, Power, Instantaneous, max, average, RMS values of alternating currents, Phaser
representation, transient and steady state analysis, Total response. Network analysis
using Laplace Transforms, properties of Laplace transforms.
Fourier Series: Continuous and discrete Fourier Transforms, z-transforms. Applications
to signal Analysis.
Convolution. Network Theorems and Applications. Two Port Parameters, Series, Parallel
and Cascade connections of two port networks, Z, Y, ABCD Parameters, Network
Functions, Poles and Zeros. Driving point and Transfer Functions, Image Parameters,
Conventional LP, HP, BP, Band Stop Filters. Composite Filters, T, ╥ & Lattice
Networks, Attenuators and Equalizers.
Electronic Devices & Circuits: PN Junction, PNP, NPN Transistors. Biasing, Tunnel
Diode, FET, UJT,SCR Characteristics, Various CB,CE,CC transistor Amplifiers –
Analysis & Performance. RC coupled and push pull amplifiers, compensation techniques,
Feedback, Negative feedback, oscillator Circuits, Phase Shift Oscillator.
Digital Circuits: Wave Shaping, multivibrators, Sweep Generators, Counters, logic
Gates and Circuits, Number Systems, Codes, Error Detection and Correction. Sequential
Circuits, Integrated Circuits OP Amps-Applications, IC Comparator Circuits, A/D, D/A
Converters.
Linear Control System: Open loop, Closed loop system, Signal Flow Graphs, Stability,
Routh – Hurwitz and Nyquist Criterion, Bode plots, Gain-phase Margin, Lead-Lag
compensation Techniques.
Transmission Lines & Antennas: Transmission line equation, Primary and Secondary
Parameters, Propagation constants, Open and Short Circuited Lines, Standing Waves,
Reflection Coefficient, VSWR, Line as Circuit element, Impedance Matching.
Maxwell’s equations and Field Theory: Various Laws & Theorems in
Electromagnetism, Plane Waves, Boundary Conditions, Concept of Radiation, Half wave
Dipole, Antenna Arrays, Communication Antennas – performance Characteristics.
Wave guides and Components: Reciprocal & non Reciprocal Wave guide components,
Couplers, Tees, Microwave Sources, Microwave Communication, Link Design.
Basics of Micro Processors & Micro Controllers: Architecture and Assemblers,
memory Devices.
Communication systems: Modulation, All types of Modulation techniques, SNR,
Analog & Digital Communication techniques, multiplexes, Demodulators, Radio
Receivers & Transmitters – Characteristics & Basics of Fibre Optics Communication and
Satellite Communication Systems.
Model Question Paper
The question paper consists of one hundred multiple choice objective type questions to
be answered on the OMR answer sheet using HB pencil in 2 hours. A few questions are
given as a model below.
Note: Calculators are not allowed into the Examination Hall. Candidates have to bring
their own pencils and erasers.
1.For reciprocal network, ABCD parameters are related as A B C D
(A ) A = D (B) B = C (C) AD – BC = 1 (D) AD + BC O O ● O
=1
2. For a short circuited transmission line, reflection coefficient is A B C
equal to O O ● O
(A) zero (B) infinity (C) –1 (D) +1
