Network Installation Sheet Ethernet Interface
Product Overview Ethernet Status LEDs
The Ethernet interface can be either top or bottom mount- LED State Indication
ed. Both options are illustrated below. LINK Green Link OK
Off Link not OK
• Top Mounted Interface
MS Green Normal operation
LAN Green, flashing Stand-by, not yet configured
IP Address Red Major fault, unrecoverable
Red, flashing Minor fault, recoverable
Alt. Red/Green Hardware self test
NS Green EtherNet/IP connection established
Green, flashing No EtherNet/IP connections
Gateway Power1 Red Duplicate IP address
Red, flashing EtherNet/IP Connection Timeout
Alt. Red/Green Hardware self test
• Front View
Off No power or no IP address set
Top mounted Network interface ACT Green Receiving or sending packet
LINK
IP Address Switches
MS
NS The onboard switches can be used to set the IP address in
ACT the range 192.168.0.1 ... 192.168.0.254 (Subnet address
Gateway Status1 255.255.255.0). If another IP series should be used, all
switches should be in OFF position. The value will then be
read from the internal configuration file.
LINK Sw. 1 Sw. 3 Sw. 4 Sw. 5 Sw. 6 Sw. 7 Sw. 8 IP Address
MS OFF OFF OFF OFF OFF OFF OFF (Set by software)
NS OFF OFF OFF OFF OFF OFF ON 192.168.0.1
ACT OFF OFF OFF OFF OFF ON OFF 192.168.0.2
Gateway Status1 ... ... ... ... ... ... ... ...
ON ON ON ON ON ON OFF 192.168.0.254
ON ON ON ON ON ON ON (Not valid)
Bottom mounted Network interface Accessories Checklist
The following items are required for installation:
• Bottom Mounted Interface
• EtherNet/IP config. tool (optional, not included)
• Null modem cable (optional, not included)
• EDS-file, required when using EtherNet/IP
Gateway Config1 (Available on the HMS website, ‘www.anybus.com’)
• Suitable LAN cable
LAN Installation and Startup Summary
IP Address 1. Connect the gateway to the network
2. Select an IP address for the Ethernet interface (Contact
LAN Connector Pinout your network administrator for more information)
3. If required, connect a PC to the gateway via null mo-
Pin Signal
dem cable
1 TD+
2 TD-
4. Power up and (if required) configure the gateway
3 RD+ 5. If required, install the .EDS file in the EtherNet/IP
4, 5, 7, 8 Termination 1 8
configuration tool
6 RD-
Support
Documentation and software downloads are available at
1. See Gateway Installation Sheet for further information the HMS webside, ‘www.anybus.com'
online: www.anybus.com Revision 1.01, Part. no. SP0750
