UPES
Electrical Cluster, School of Advanced Engineering
ASSIGNMENT- I
Programe Name: B. Tech- Electronics & Computer Engineering I- Semester
Submission date: 04/10/2024
Course Name/Code: Basic Electrical and Electronics Engg/ ECEG-1004 Max. Marks: 100
Note: Attempt all the questions.
Q-1: Explain the behaviour of diode in forward and reverse biasing. Sketch the V-I
characteristic with related terminology. CO1 10 Marks
Q-2: Determine the current I1, I2 and I3 Figure (1).
CO1 5 Marks
Figure (1)
Q-3: Figure 2 shows the Full bridge type circuits having the load resistance and
transformer turn ratio. The primary of each is connected to 230 V, 50 Hz supply CO1 10 Marks
(i) Find the d.c voltage
(ii) Find the RMS voltage
(iii) Efficiency
(iv) Ripple factor
(v) PIV for each case for the same d.c output.
(vi) Draw the output waveform of the rectifier with proper voltage and
time sale levels.
Assume the diodes are ideal (Silicon).
Figure 2
Q-4: For the circuit shown in Figure (3), find the maximum and minimum values of
Zener diode current. CO1 10 Marks
Figure (3)
Q-5 Analyze the DC load line and importance of operating point (Q) of Bipolar
Junction Transistor (BJT) and show the operating regions of the transistor. CO1 05 Marks
Q-6 Draw and analyze the Common Base, Common emitter and Common Collector CO1 10 Marks
connections of transistors. Also sketch the input –output characteristics.
Q-7 Attempt both the parts: CO1 10 Marks
(A) Write short note on the following: (i) Operating point-Q (ii) DC load line
(iii) current gain
(B) Determine whether or not the transistor in Fig. (4) is in saturation.
Assume knee voltage =0.2V.
Fig. (4)
Q-8 Convert the numbers into:
(a) (10111.001)2= ( ? )10= ( ? )16
(b) (235.52)8 = ( ? )16 = ( ? )10 CO2 10 Marks
(c) ([Link])16 = ( ? )10= ( ? )2 = ( ? )Gray Code
(d) (ABC23.12)16 = ( ? )8 = ( ? )10
Q-9 Design NOT, AND and OR logic gates using (i) NAND (ii) NOR universal logic gates.
CO2 10 Marks
Q-10 Minimize the following Boolean expressions and realize the minimized expression
through the basic logic gates. CO2 10 Marks
__ __ __ __ __ __ __ __
Y AB C D A B C D A BC D ABC D
Q-11 Determine the output expression for the circuit shown in Figure (5) below and simplify it
using De-morgan’s theorem and convert the output expression in the form of product of CO2 10 Marks
sum (POS).
Figure (5)
