One of your teammates tries to return to traditional national schools and you try to
convince him/her to stay in STEM system. Give him / her two pieces of advice
depending on the capstone project as something unique in STEM schools*
Personal Reflection/Team Collaboration
Let us think together in advanced way
What the advantage of being returning to traditional national schools?? Nothing.
You will just lose the advantage of being a student in stem school. it is not that
worse; it might be difficult little bit, but you cannot let yourself to lose all of that to.
If you are afraid of the final grade, it is a normal thing, but the capstone helps us to
collect marks. If you study hard and get ready for the journals, you must get the
best grades and you must get the blue which is the best. You are work in a team,
that must make the work easy to finish if you work in collaboration. Also if you were
good in capstone work, the teams will try to deal with you to be with them in the
same team. As I am your current team mate, I should help you to pass that bad
time. We can write our tasks together to get the benefit of our information. Stay
with me do not let.
Therefore, capstone work makes us able to deal with our problems in our real life, as
the engineering design process (EDP). Before you know that way to solve your
problems you were not that comfortable if you face problems. The way train us to
know how to think actually to solve your problems.
You got a lot of readings on your prototype test. Some of them were accepted and
others were rejected. Explain two criteria for(your selection) accepting and rejecting
some readings.
During impleminting the test results of the prototype in your portifolio,you've
chosen some results and ignored others .Explain with examples two criteria you
used for both decisions.
*
Using the Engineering Design Process (EDP)
well, first of it all, the final test plane was done and the results were meat the
design requirements, but there were some results that were rejected like lacing of
the polluted air. The reading of the sensor was not accurate. we could not determine
the real reading so the prototype was need to improve it more. also the activated
carbon layer was much thin to purify the air and improve its quality, it was an
another problem which is need to solve and a rejected results we do not want it to
happened.
So, we needed to improve the prototype, using (EDP) Engineering Design Process
we tried to solve these problems. For the lace: glass was used to make the
container, but it did not get the needed efficiency. We started searching for another
material and we found that the acleric is good to use. We bought what we needed
then we made the container. After that, another test plan was done with the new
material. No lacing was observed, and the reading of the sensor was acceptable and
in high efficiency,
For the activated carbon layer: it wase so thin so the purified air was not that good.
So, we tried to increase its thickness and make the carbon more activate to get the
best results. We opened the pad panel filter layer that the activated carbon was in
the inside of it, then we started to increase the activated carbon and finally close it
as it was. Then it was put in the container and the glow used to make it tape with
the sides of the container
On the other hand, there were a perfect results meat the successful project design
requirements.
