Scribd
Upload
11 views

AnalogCourse_S4

Uploaded by

powerelectronicscareer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views

AnalogCourse_S4

Uploaded by

powerelectronicscareer
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Analog Circuit Design Course(S-4)

30 Hours + Project
Amit Bar || Analog IC Design Engineer || B.E. @Jadavpur University

A. Typical Section:
1. Basic Electrical Networks and Circuit Theory
2. Signals, Systems and Control Engineering
3. Semiconductor Physics
4. Analog Circuits 1 & 2
[Everything related to Analog Circuit Design fresher position will be taught]

B. Advanced Section:
i. Analog IC Design
1. Negative feedback, Open Loop, Closed Loop
2. Bode Plot, Phase Margin, Gain Margin, UGB, Pole-Zero
3. Single Stage op-amp: Block Level to transistor Level Design
4. Two Stage op-amp: Block Level to transistor Level Design
5. Feed forward Op-amp
6. Cascade and folded cascade op-amp
7. CMOS process
8. Noise in ICs

ii. Industry Level Analog Block Design:


1. Biasing Circuits (Voltage & Current Reference)
2. Constant Gm Bias
3. Two Stage Miller's op-amp (Compulsory)
4. High Speed Comparator
5. BGR
6. CMOS Level Shifter
8. LDO
[Core Design Concepts & Theory & implementation Challenges]

Mail - [email protected]
Analog Circuit Design Course(S-4)
30 Hours + Project
Amit Bar || Analog IC Design Engineer || B.E. @Jadavpur University

C. Placement Section:
i. Resume Review
ii. Mock Written Test
iii. Mock Interview
iv. One to One Guidance

D. Project Section:
One real life project like Two Stage op-amp, Comparator, Level Shifter, Constant Gm Bias, BGR, LDO etc.
[You should have cadence/ LTSpice tools for D]
i. Typical Simulation
ii. PVT Simulation + Typical Simulation

E. Special Section:
Complete (real life design on Cadence) Design Discussion on:
1. Inverters, Buffers
2. Mux, Combinational Logic gates
3. Latch, Flip-Flops
4. Switches
5. Gate-Driver
6. Dead Band
7. Current Sensing Block
8. POR (power on reset)
9. Special types of comparators
10. Special types of Opamp
11. DC Shift Block
12. Sample-Hold Circuit
13. Start-Up Circuit
14. Charge Pump PLL
15. Ring Oscillator
16. BGR Calibration Circuit
17. BGR
Mail - [email protected]
Analog Circuit Design Course(S-4)
30 Hours + Project
Amit Bar || Analog IC Design Engineer || B.E. @Jadavpur University
18. LDO (both External & internal Cap)
19. Buck Regulator
20. SAR ADC
21. Current Steering DAC
22. Charge Pump Regulator
23. C-DAC

[E is mainly for industry people]

Mail - [email protected]

You might also like