A

PROJECT REPORT

ON

“Project Name”

in partial fulfillment of

BCA III Year/V Semester

Session 20xx-20xx

Submitted To: Submitted by:

Name of faculty Name of Student

Designation BCA, Semester,Year

Department of Computer Application

Guru Nanak Institute of Management & Technology

Ludhiana, Punjab
 Certificate

This is to certify that the Minor Project entitled “PROJECT TITLE” has been carried out by the
student/team of college Guru Nanak Institute of Management & Technology, Ludhiana under my
guidance and supervision in partial fulfillment of the degree of Bachelor of Computer Applications of I. K.
Gujral Punjab Technical University, Jalandhar during the academic year 20xx-20xx.

Team:

1. Name of the student 1(PTU Roll-No)

2. Name of the student 2(PTU Roll-No)

Date:

Place: GNIMT, Ludhiana

Signature of Guide Signature of H.O.D

----------------------------------- --------------------------------------

Name of Guide Name of H.O.D

Designation Head Of Department

Department of CA, GNIMT Department of CA, GNIMT

 Acknowledgment

Name of Student

Date
Abstract
 Table of Contents

Certificate..................................................................................................1

Acknowledgment......................................................................................2

Abstract.....................................................................................................3

Table of Contents.....................................................................................4

1. Introduction..........................................................................................5

2. Literature Survey.................................................................................6

3. Requirement Specification..................................................................7

4. Architectural Design............................................................................8

5. Test Planning........................................................................................9

6. Work Distribution..............................................................................10

7. Results..................................................................................................11

8. Conclusion & Future Work...............................................................12

Glossary...................................................................................................13

References...............................................................................................14
1. Introduction

This section should describe the basic introduction of the project scenario which is going to be
implemented during this lab.

This section should also cover the following points:

Technology/Programming Languages/Databases Involved:-

[Mention the technology, programming languages and Database which you are going to use during the
implementation of the project.]
2. Literature Survey

This section should cover the complete literature details which has been referred during the execution of
the project scenario.

The literature survey should cover the following points

1. Any website which has been referred.

2. The content of the section/chapters of the book which has been referred should be mentioned here in
this section.

3. The content of the section of the papers which has been referred should be mentioned here in this
section.
3. Requirement Specification

Put Complete SRS here.

The following section of SRS document will be mentioned over here.

a. Section 2.0 “General Requirements”

4. Architectural Design

Place those section of SDD document which are applicable to your project.
5. Test Planning

Place those section of TPD document which are applicable to your project.
6. Work Distribution

The work distribution during the implementation of the project scenario has to be mentioned in this
section. If more than one student are involved in the project, then each of the student has to
submit the individual implementation plan. Each plan should be in the following below format.

Name of function/ Start Date End Date Responsible Person

module

Write down the Mention the date Mention the Mention the name of
name of the when the completion date for the student/team
function/module implementation of the implementation of member who is going
which is going to be function/module is function/module. to implement the
implemented in the going to be started. function/ module.
given timeline.
7. Results

This section should contained the following points mentioned below.

Working Snapshots

 <Snapshot Title>

Write 1-2 line description of snapshot the paste snapshot here.

 <Snapshot Title>

Write 1-2 line description of snapshot the paste snapshot here.

 <Snapshot Title>

Write 1-2 line description of snapshot the paste snapshot here.

Test Status Report

S. No. Module Name Status (Pass/Fail)

Error Status Remarks
(Fixed/Open
Write down the Write the Module Mention the status Mention the status Mention the
S.No. name here. of test case after of the bug, process in brief
the testing. whether it is how it has been
fixed or open. closed. Or if
remained open
then why
8. Conclusion & Future Work

This section should brief about the project work which has been done. Mention the limitation or any
performance achievement occurred during the execution of the project.

Mention the work/enhancement which can be done on the project in the future.

Glossary

Write here the list of Abbreviations and Acronyms in tabular form and definitions of

the terms which need to be described.

References

Mention the reference used in the project

a. Any books which have been referred.

b. Any websites which have been referred.

c. Any source code which have been referred.

d. Any previous year project report which have been referred.

Literature References (IEEE Syntax), Examples are given as under:

a.“To refer a research paper” - Dinesh Birla, R. P. Maheshwari, and H. O. Gupta, “A New Non-linear
Directional Overcurrent Relay Coordination Technique, and Banes and Boons of Near-end Faults Based
Approach”, IEEE Transactions on Power Delivery, vol.-21,no.-3, pp. 1176-1182, July 2006

b.“To refer a book” - David E, Goldberg, “Genetic Algorithms in Search, Optimization, and Machine
Learning”, ISBN 81-7808-130-X, Pearson Education Asia Pty Ltd., 2000. (621.381952,G47G