A

Prepared By :- Innovative Education Point

उतर पुस्ततकामा प्रश्नपत्रको key अस्ि वायय रुपले उल्लेख िियुिपे छ | उल्लेख ि िरे मा उतर पुस्ततका रद्ध हुि े छ | साथै पररक्षामा calculator
,Mobile जतता स्वधुतीय उपकरण प्रयोि ििय पाि े छै ि |

1) The two peg method is used to check the parallelism between the
a) Line of collimation and axis of bubble tube
b) Line of collimation and axis of telescope
c) Axis of bubble tube and vertical axis
d) All of the above
2) The height of instrument method is
a) Less tedious
b) More rapid
c) Includes less calculation
d) All of the above
3) If the included angle is greater than 1800 , deflection angle is
a) Right handed
b) Left handed
c) 900
d) None
4) Horizontal equivalent of uniform slope must be
a) Equal
b) Unequal

1
c) Contour interval
d) None
5) Which of the following is a rock?
a) Augite
b) Gypsum
c) Calcite
d) Mica
6) Workability is tested by
a) Slump test
b) Vee bee test
c) C.F. test
d) All of the above
7) Excess of silica in brick earth causes
a) Loss of cohesion
b) Impermeable
c) Cracking and warping
d) brittleness
8) Seasoning of timber is essential to remove
a) Knots
b) Sap from timber
c) Twisted fiber from timber
d) Roughness of timber
9) If the elasticity of the material is zero then material is said to be
a) Rigid
b) Perfect
c) Plastic
d) All of the above

2
10) Which of the following end conditions permits the displacement in any direction and
also rotation
a) Fixed end
b) Hinge end
c) Free end
d) Roller end
11) The number of points of contraflexure in a simply supported beam carrying UDL , is
a) 1
b) 2
c) 3
d) 0
12) BM in a cantilever beam having span 1.8m and uniformly distributed load of 4 kg/m
a) 4.48 kg-m
b) 5.48 kg-m
c) 6.48 kg-m
d) None
13) A flow is said to be laminar when
a) The fluid particles moves in a zig-zag way
b) The Reynolds number is high
c) The fluid particles move in layers parallel to the boundary
d) None of the above
14) Head loss increases with
a) Increase in velocity
b) Decrease in velocity
c) Decrease in length of pipe
d) Increase in diameter of pipe
15) To measure very low pressure, we use

3
a) Barometers
b) Piezometers
c) Manometers
d) Differential manometers
16) Super critical flow occurs in
a) Normal slope
b) Mild slope
c) Steep slope
d) All of the above
17) The effective size of particle of soil is given by
a) D10
b) D20
c) D30
d) D60
18) Total lateral earth pressure is proportional to
a) Depth of soil
b) Square of depth of soil
c) Angle of internal friction of soil
d) None of the above
19) The bearing capacity of a soil depends upon
a) Grain size of the soil
b) Load intensity
c) On the load
d) Rate of loading
20) A soil sample contains a degree of Saturation is 30% , find the percentage of air voids
a) 70%
b) 30%

4
c) 60%
d) 50%
21) The approximate allowable stress in bending compression in RCC is
a) 0.25fck
b) 0.33fck
c) 0.44fck
d) None
22) The maximum spacing between longitudinal bars in a column is
a) 200mm
b) 300mm
c) 400mm
d) 500mm
23) Diagonal crack is introduced in a beam due to
a) SF
b) BM
c) SF & BM
d) None
24) The types of plaster generally used for celling is
a) 1:4
b) 1:3
c) 1:2
d) 1:1
25) The maximum height of masonry wall done in one day is
a) 0.5m
b) 1m
c) 1.5m
d) 2m

5
26) W/C ratio for M10 concrete should be
a) 0.65
b) 0.5
c) 0.4
d) 0.35
27) In made up ground having a low value of bearing power, heavy concentrated load is
generally supported by
a) Combined footing
b) Starp footing
c) Raft footing
d) All of the above
28) Septic tank is provided for
a) To eliminate the sewer system
b) Tank for sedimentation cum disposal under aerobic condition
c) Oxygen free sedimentation cum disposal under anaerobic condition
d) None of the above
29) Water for domestic consumption should be
a) Hygienically safe
b) Colourless, odourless & tasteless
c) Free from dissolved salts
d) Attractive for looks
30) The minimum diameter of a sewer pipe should be
a) 5 cm
b) 10 cm
c) 15 cm
d) 25 cm
31) Turbidity is ability of water to

6
a) Scatter light
b) Retain suspended solids
c) Retain colloidal solids in suspension
d) Detain dissolved solids
32) The maximum velocity in a circular channel of diameter D occurs when the depth of
flow is
a) 3.50D
b) 0.73D
c) 0.81D
d) 0.90D
33) The meandering river is always
a) Maximum discharge
b) Average discharge
c) Dominant discharge
d) None of the above
34) Vertical drop fall is suitable for a discharge
a) 10 m3/sec
b) 15 m3/sec
c) 60 m3/sec
d) Any discharge
35) Which of the following has maximum water application efficiency?
a) Surface irrigation
b) Lift irrigation
c) Sprinkler irrigation
d) Furrow irrigation
36) Which one is not concerned with cross section road ?
a) Camber

7
b) Thickness
c) Width
d) Gradient
37) In hill roads of Nepal, the side drains are provided
a) Hill side of road
b) Outer side of road
c) Both side of road
d) None of the above
38) Radius of transition curve at the junction of circular curve is
a) R/2
b) R
c) 2R
d) 0
39) The length of vehicle has effect on
a) Width of shoulders
b) Traffic volume
c) Traffic capacity
d) Traffic density
40) Payment of the steel is done by
a) Per quintel
b) Per MT
c) Per thousand
d) Per bundle
41) Rate analysis is based on the following factors
a) Quantity of materials
b) Quality of materials
c) Rate of materials

8
d) All of the above
42) The excavation exceeding 1.5m in width and area 10m2 with a depth not exceeding
30cm is termed as
a) Excavation
b) Cutting
c) Surface dressing
d) Surface excavation
43) How many kilo-liters are in one cubic meter?
a) 0.5
b) 1
c) 10
d) 100
44) Line organization is mostly suitable for
a) Simple work
b) Complicated work
c) Both a and b
d) None
45) A dummy activity in CPM
a) Had no tail event but had only a head event
b) Had only a head event but no tail event
c) Does not require any resources or any time
d) Had no sequence and can be fitted anywhere
46) In CPM , the actual performance of task is called
a) An event
b) An activity
c) A duration
d) Critical task

9
47) The maximum amount for approval of tender by Gazetted 3 rd class officer is
a) One crore
b) Three crore
c) Five crore
d) Seven crore
48) The length of runway is increased per 300m rise above M.S.L
a) 4%
b) 5%
c) 6%
d) 7%
49) The minimum basic runway length of class A type airport is
a) 600m
b) 2100m
c) 750m
d) 1500m
50) According to the international civil Aviation Organization . the runway lengths of
aerodromes, have been coded by
a) Seven English alphabet
b) Last Seven English alphabet
c) First five English alphabet
d) First five natural numbers

10
 CIVIL SUB-ENGINEER ANSWER KEYS
1 2 3 4 5 6 7 8 9 10
a d a a b d d b a c
11 12 13 14 15 16 17 18 19 20
d c c a b c a b a a
21 22 23 24 25 26 27 28 29 30
b b a b b a c c a c
31 32 33 34 35 36 37 38 39 40
a c c b c d a b d b
41 42 43 44 45 46 47 48 49 50
d d b a c b a d b c

11
12
13