Box Sheet for Order code: HD67616-A1
Document code: BS67616-A1
V1.000
Electronic Devices
NMEA 0183 / ModBus Slave Converter
To obtain the complete manual please go to:
www.adfweb.com/download/filefold/MN67616_ENG.pdf
To obtain the new version of this box sheet please go to:
www.adfweb.com/download/filefold/BS67616-A1_ENG.pdf
CONNECTION SCHEME:
Dip-Switch A: OFF
-Dip1 – Must be at ON
-Dip2 – Functioning Mode 1 2
ON
Connector 4:
OFF OFF
RS232 Port (D-SUB9-Male)
1 2
= Normal 1 2
= Boot (Isolated Port)
ON ON
Led4:
Green PIN2 = RX
Modbus PIN3 = TX
communication PIN5 = GND* (to Isolated Ground)
Led3: Used for:
Green - Programmation Port
NMEA 0183 - Modbus on RS232
communication
To connect the device to the COM
port of a PC in order to set it
you have to use the programming
cable AC34107 or a cable made as
showed here:
Rail DIN
Clamp Led2:
Green
5 4 3 2 1
9 8 7 6
Ethernet Link
Connector5:
Ethernet Port
(RJ45 Plug)
Led1:
Green CABLE CABLE
Device state Side A Side B
Dip-Switch B:
A B S A B S +V 0V FEM FEM
-Dip1 – RS485 Termination Resistor
OFF OFF ON ON
Connector1:
1 2 1 2
1 2
= Open 1 2
= 120 Ohm
ON ON OFF OFF
Power Supply port
-Dip2 – Not used
0V = Ground
+V = Positive wire
Connector3: Dip-Switch C: Connector2:
RS485 1 Port (Isolated port) -Dip1 – RS485 Termination Resistor RS485 2 Port (Isolated port) V AC: min 8V ; max 24V
OFF OFF
V DC: min 12V ; max 35V
S = Shield* (to Isolated Ground) = Open = 120 Ohm S = Shield* (to Isolated Ground)
1 2 1 2
B = Negative wire ON ON B = Negative wire
A = Positive wire -Dip2 – Not used A = Positive wire
CONFIGURATION SOFTWARE:
For setting up the device you need the software named SW67616. To obtain this software
please go to:
www.adfweb.com/download/filefold/SW67616.zip
ADFweb.com s.r.l.
www.adfweb.com
[email protected]
Manual Box-Sheet Software
