INSTRUCTIONS
Pants “Vicky”
Model 322-26
Sizes 36 – 48
PRINT THE CUT INSTRUCTIONS
1. Open the pattern PDF and set the control square to 1. Thread the overlocker for a 4-thread overlock or a 3-
Page 1 with the setting "Original size" on DIN Print A4 thread super stretch stitch. Close the side seams. Close
paper ( US-Letter ). ( Do not click on "Adjustment to page the front and the rear centre seams and the inner leg
size"! ) seams.
2. Check the square – if it is 10 × 10 cm, print out the whole
cut sheet. 2. Place the waistband wrong side on wrong side. Mark the
3. Place all pages next to each other as indicated by the front centre and define the centre of the eyelet 4,5 cm
arrows and adhere them row by row along the boundary to the right and left of it, 2.2 cm below the folded edge.
lines, then glue the rows together. Cut two squares of fabric interlining with an edge length
4. Compare the body measurements with the table of 3.5 cm and iron them centrally behind the eyelet
measurements and cut out the cut parts in the appro- centres. Sew a square of 2 × 2 cm around the centre. Cut
priate size. ( The overview of the cut parts is on the the hole with an allowance. Place the eyelet patches over
pattern sheet. ) the holes and stitch them on. Use the Zipper Foot #4 for
Important: Instructions do not include seam allowances, this purpose, if necessary. Close the waistband to form a
unless otherwise indicated! ring, leaving an opening in the inner waistband for the
elastic.
SUPPLIES 3. Divide the waistband and the top edge of the trousers
into quarters. Sew the outer side of the waistband
• 1.2 – 1.9 m knitted fabric, 160 cm wide slightly stretched right side on right side along the upper
• 0.8 – 1.1 m elastic, 3,5 cm wide edge of the trousers, placing the waistband seam in the
• 1 – 1.3 m ribbon, 15 mm wide ( Veno ) rear centre. Finish the inner long edge and pin it in place.
Sew on the waistband from the right in the seam
• 2 eyelet patches ( Veno )
shadow. Pull in the elastic and sew it together at a
• Remnant of woven interlining G 700 ( Vlieseline )
comfortable width. Topstitch the upper edge of the
• 2 cord ends ( Prym )
waistband and the elastic from the top 0.5 cm wide,
• BERNINA Dual Feed or Walking Foot #50
stretching the waistband so that it lies flat. Insert the
• Elastic sewing thread “SeraFLEX” ( Mettler ) ribbon, thread the cord into the cord ends, and knot the
• BERNINA Overlocker L 890 ribbon ends.
4. Thread the overlocker for a coverstitch. Iron up the hems
CUTTING
of the pants and hem them.
1 2 × front part
2 2 × back part
Waistband 86/90/94/98/102/106/110 × 9 cm, final width
4.5 cm.
