Scribd
Upload
9 views

Worksheet (1)

Worksheet

Uploaded by

yididyashimelis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
9 views

Worksheet (1)

Worksheet

Uploaded by

yididyashimelis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Fundamentals of Electrical Engineering (EPCE2101)

Worksheet Academic Year: 2024/2025


1. Refer to the circuit shown in the following figure. Calculate:
(a) v (0+), d v (0+) / dt
(b) v (t)

2. Determine i(t) for t > 0 in the following circuit.

3. Use nodal analysis to find v0 in the circuit given below.


Let vs1 = 120 cos(100t + 90⁰) V and vs2 = 80 cos(100t) V.

4. Use Thevenin and Norton theorems to find v0 in question 3.


5. A 110-V rms, 60-Hz source is applied to a load impedance Z. The apparent power
entering the load is 120 VA at a power factor of 0.707 lagging.
a) Calculate the complex power.
b) Find the rms current supplied to the load.
c) Determine Z.
d) Assuming that Z = R + jωL, find the values of R and L.
6. Consider the power system shown below. Calculate:
a) the total complex power
b) the power factor
c) the parallel capacitance necessary to establish a unity power factor

1|Page
7. A 240-V rms 60-Hz supply serves a load that is 10 kW (resistive), 15 kVAR
(capacitive), and 22 kVAR (inductive). Find:
a) the apparent power
b) the current drawn from the supply
c) the kVAR rating and capacitance required to improve the power factor to 0.96
lagging
d) the current drawn from the supply under the new power-factor conditions
8. For the following circuit, find the transfer impedance. Plot the frequency response.

9. A circuit consisting of a coil with inductance 10 mH and resistance 20 Ω is connected


in series with a capacitor and a generator with an rms voltage of 120 V. Find:
a) the value of the capacitance that will cause the circuit to be in resonance at 15
kHz
b) the current through the coil at resonance,
c) the Q of the circuit, the half-power frequencies,
d) the bandwidth, half-power frequencies.

2|Page

You might also like