Integrated Video Site
PowerCube 500 – 200H1
Introduction
Huawei PowerCube 500 is an integrated video site solution,
which is used for power supply and service transmission of a
range of low-power devices. It is widely applied to video
surveillance scenarios such as safe city projects, highways,
campuses, scenic spots, and forest fire prevention. With its
integrated design, this solution is highly reliable in harsh outdoor
environments and solves problems regarding power supply and
data backhaul at video sites. Moreover, it implements intelligent
Front Front-side Rear-side
remote management to improve the online rate across video view view view
sites while significantly reducing O&M investment.
Features
Simple Deployment
• 12 V DC, 24 V DC, 24 V AC, PoE, PoE+, PoE++ output
• Small size, light weight, and one-stop pole-mounted installation
Reliable Power Supply (Supporting Mains, Solar Energy, and
Lithium Batteries)
• IP rating: IP55
• Lithium battery service life: 5 years
Flexible Service Transmission
• Multiple services: Ethernet, microwave, GPON
Intelligent Management
• Unified remote management with high efficiency
• Web-based local maintenance
Scenario
Video surveillance sites
Network transmission sites
Other low-power consumption sites
Power System Specifications
Module Power Module PC500-200H1
Dimensions (W x D x H) 300 mm x 150 mm x 570 mm
Weight < 16 kg
Battery capacity N/A
Heat dissipation Natural heat dissipation
Installation Pole-mounted or wall-mounted
System
Pole diameter 105 mm to 210 mm
Cable routing Routed in and out from the bottom
Noise level ≤ 65 dB(A)@1.5 m, complying with the GR487 standard
IP rating IP55
Network access Ethernet, microwave, GPON
Mains input mode 220 V AC, single phase
Mains input voltage Rated 220 V AC
Solar input voltage 36 V DC to 120 V DC
MPPT precision ≥ 98%
Input frequency 45 Hz to 65 Hz (rated 50 Hz)
2x12 V DC (≤ 72 W)
2x24 V DC (≤ 58 W)
Output voltage
2x24 V AC (≤ 100 W)
6xPoE/PoE+/PoE++ (48 V DC) (≤ 200 W)
Rated output power 200 W
AC/DC Distribution • AC input: 20 kA (8/20 μs) in differential mode, 20 kA (8/20 μs) in common
mode, criterion C
• Solar DC input: 3 kA (8/20 μs) in differential mode, 5 kA (8/20 μs) in common
mode, criterion C
• 12 V DC output: 3 kA (8/20 μs) in differential mode, 5 kA (8/20 μs) in common
mode, criterion C
• 24 V DC output: 3 kA (8/20 μs) in differential mode, 5 kA (8/20 μs) in common
Surge protection mode, criterion C
• 24 V AC output: 2 kV in differential mode, 6 kV in common mode, criterion C
• –48 V DC output (PoE): 3 kA (8/20 μs) in differential mode, 5 kA (8/20 μs) in
common mode, criterion C
• –48 V DC output (battery port): 3 kA (8/20 μs) in differential mode, 5 kA (8/20
μs) in common mode, criterion C
• Communications port: 250 A (8/20 μs) in differential mode, criterion C; 3 kA
(8/20 μs) in common mode, criterion C
Communications Communications port 1 x DB9 (CAN)
–40°C to +55°C (without sunlight exposure)
Operating temperature
–40ºC to +45ºC (with sunlight exposure: 1120 W/m2)
Storage temperature –40ºC to +70ºC
Operating humidity 5% to 95% (without condensation)
Environment
–150 m to 5000 m
Altitude (When the altitude ranges from 2000 m to 5000 m, high temperature derating
applies and the operating temperature decreases by 1°C for each additional 200 m.)
Salt spray resistance Salt spray resistance in areas that are more than 500 m away from the sea
Network System Specifications
Module Power Module PC500-200H1
Ethernet/GPON/Microwave*:
Service ports 2xSFP (GE optical, GPON)
6xGE (PoE/PoE+/PoE++)
Transmission rate: 1.244 Gbit/s (TX), 2.488 Gbit/s (RX)
GPON Optical fiber: single mode, SC/UPC
Maximum transmission distance: 20 km
AUX port 1 NMS port, WLAN module, 1-input & 1-output alarm port
Physical fault detection, including status monitoring and alarm reporting of all
Fault detection
service ports and status monitoring of inserted modules
E-Line (E2E, VLAN, QinQ): 1024
Service types
E-LAN (802.1d, 802.1q, 802.1ad): 16
Network Service protection ERPS (v1/v2), SEP, LAG, wired/wireless service backup
VLANs 1 to 4094
MAC addresses Static: 16384; dynamic: 512
LAG Manual/Static aggregation, load sharing/non-sharing
Protection switching LAG/ERPS < 50 ms, SEP < 100 ms
QoS Eight queues, SP+WRR, DiffServ, IEEE 802.3x flow control, CAR, Shaping
E-Line/E-LAN, eight QoS queues, SP+WRR, DiffServ, IEEE 802.3x flow control,
Ethernet service
CAR, Shaping, SEP
IEEE 802.1x for access authorization
Security and reliability Theft-proof design
Wireless service backup
Unified management on the eSight, web-based network management system
OAM OAM
built in the equipment
* Optical modules are required for GPON transmission. External microwave devices are required for microwave backhaul.
Copyright © Huawei Technologies Co., Ltd. 2021. All rights reserved.
HUAWEI TECHNOLOGIES CO., LTD.
No part of this document may be reproduced or transmitted in any form or by any means without the prior written
consent of Huawei Technologies Co., Ltd. Huawei Industrial Base
Disclaimer Bantian Longgang
The information in this document may contain predictive statements including, without limitation, statements regarding Shenzhen 518129, P.R. China
the future financial and operating results, future product portfolio, new technology, etc. There are a number of factors
that could cause actual results and developments to differ materially from those expressed or implied in the predictive Tel: +86-755-28780808
statements. Therefore, such information is provided for reference purposes only and constitutes neither an offer nor a
www.huawei.com
commitment. Huawei may change the information at any time without notice.
