An ISO 9001:2015 Cer fied Companyy ORDER CODE: SSM24BIS03-SMPS-BCBKEY

SMPS CUM BATTERY CHARGER 24V 03A

FEATURES

Ÿ Latest state-of- the-art current mode PWM controller and MOSFET based design.
Ÿ Power supply unit & electronics switch over unit are in the same housing.
Ÿ Provision for two 12V 7AH maintenance free battery.
Ÿ LED indications for AC OK, DC OK and Low Battery.
Ÿ Soft start circuit to limit the AC inrush current.
Ÿ Reliable even at high ambient temperature.
Ÿ BIS Approved.
Ÿ
Ÿ

SPECIFICATIONS
Input voltage 150-265VAC*
Frequency 45-60Hz
Inrush current <38A
AC current consump on 3A
Input Indica on AC OK- Yellow LED
Characteris cs Input protec on 3A Subminiature fuse (Time-Lag type)
Transient surge protec on Yes (varistor)
Filter EMI/RFI
Buffer me >20msec at full load
Efficiency >80%
Nominal voltage 24VDC
Voltage adj. range 24-27VDC
Nominal current 03A (including ba ery charging current)
Ba ery charging current Up to 1A
Maximum output power 81W
Line regula on < +/- 0.5%
Output Load regula on < +/- 0.5%
Characteris cs
Ripple and noise < +/- 1% P-P
Low ba ery cut off Yes, at 22VDC +/-1V
Indica ons DC OK- Green LED, LOW BAT-Red LED
Connec on in parallel Yes, with diode ORing
Over voltage protec on Yes, normally works within 28-33VDC

Over load protec on Yes, normally works within 102-150% of rated

nominal current
Short circuit protec on Yes

Page 1 of 3 SSM24BIS03-SMPS-BCBKEY Dt:30/09/21 V2

An ISO 9001:2015 Cer fied Company

SPECIFICATIONS

Ambient temperature (opera on) 0°C - 60°C

Environmental Ambient temperature (storage) 0°C - 75°C
Characteris cs Rela ve humidity 95% at 25 °C, non condensa on
Cooling Natural air convec on
Safety standard IS 13252 (Part-1), IEC 60950-1
Insula on voltage I/P-O/P 3.0KVAC
Insula on voltage I/P-PE 1.5KVAC
Safety Insula on voltage O/P-PE 500VAC
Characteris cs
Isola on resistance I/P-O/P >100mega ohm @500DC min.
Isola on resistance I/P-PE >100mega ohm @500DC min.
Isola on resistance O/P-PE >100mega ohm @500DC min.
Installa on posi on Wall moun ng
General Type of connec on Screw type connec on (0.2 sq.mm-2.5 sq.mm)
Characteris cs Weight 2.5 Kg
Dimension (LXWXH) 382 X 70 X 201 mm

INSTALLATION POSITION

2 0 1 .0

7 0 .0

3 8 2 .0

1 6 .0

1 9 8 .0 1 7 4 .0

8 .0
8 .0 3 6 3 .0 8 .0
3 7 9 .0

Page 2 of 3 SSM24BIS03-SMPS-BCBKEY Dt:30/09/21 V2

An ISO 9001:2015 Cer fied Company

CONNECTION DIAGRAM

SSM24BIS03-SMPS-BCBKEY

SSM24BIS03-SMPS-BC

E N L -V +V -V +V -V +V -B +B

230VAC @50Hz 24VDC @02A

INPUT OUTPUT TO LOAD Switch
- 24V +
Ba ery
Module

DERATING CURVE OUTPUT DERATING VS INPUT VOLTAGE

100 100

80 80
Load (%)
Load (%)

60 60

40 40

20 20

00 10 20 30 40 50 60 70 80 90 130 160 190 220 250 280 310

Input Voltage (VAC)

Ambient Temperature (°C)

NOTE
1) The license number assigned for BIS approval is R-71014273.
2) Highest input opera ng voltage is 300VAC.
3) Please do not connect ba ery below 23VDC.
4) Recommended to connect the ba ery module via a switch for remote shutdown.
5) All these parameters are specified at 230VAC@50Hz input voltage and ambient temperature (+25°C).
6) Two 12V DC rechargeable ba eries of same capacity must be connected in series for 24VDC ba ery module.
7) For con nuous improvement, specifica ons subject to change without prior in ma on.

VOCAL
for
LOCAL
An ISO 9001:2015 Cer fied Company
Make in India
+91 7104 242577 l +91 97655 57591-99
[email protected] I www.micropower-india.com
Page 3 of 3 SSM24BIS03-SMPS-BCBKEY Dt:30/09/21 V2