CALIBRATION OF CAT C12 ENGINE - PDF
Uploaded by
ScribdTranslationsCALIBRATION OF CAT C12 ENGINE - PDF
Uploaded by
ScribdTranslationsCAT C12 ENGINE CALIBRATION
FIRST ROUND _ piston number 1 at the top dead center position on the compression
stroke and piston number 6 in overlap, install the timing pin into the flywheel.
CALIBRATE ON THE CYLINDERS
intake valve 1, 2, and 4 clearance
exhaust valve 1, 3, and, 5 adjustment(0.015)in
clearance
injectors 3, 5, and, 6 180 degree adjustment
Engine brake 1, 3, and, 5 Clearance
Adjustment(0.040)in
SECOND Turn _ remove the timing pin and turn the flywheel 360 degrees in the
direction of engine rotation. This will put the number 6 piston in the top center position
on the compression stroke and the number 1 piston in overlap, install the timing pin into
the flywheel.
CALIBRATE ON THE CYLINDERS
Intake valve 3, 5, and 6 Clearance
Exhaust valve 2, 4, and 6 Adjustment(0.015)in
Clearance
injectors 1, 2, and 4 180 degree adjustment
Engine brake 2 4, and 6 Clearance
SPECS Adjustment(0.040)in
_ valve rocker arm adjuster lock nut torque (18+-5 lbs. ft.)
_ injector regulator lock nut torque (41+-7 lbs, ft)
_ engine brake slave piston adjuster lock nut (25 lbs. ft.)
_ rocker arm assembly pin and stud torque (75+-15 lbs. ft.)
_ engine brake nut torque (60+-11 lbs, ft)
_ engine brake bolt torque (41+-7 lbs, ft)
_ pin torque with injector head (25, lbs, ft)
INJECTOR ADJUSTMENT
_ Loosen (back off) the injector screw, turn the Unit Injector adjusting screw
clockwise until contact is made with the Unit Injector.
_ turn the unit injector adjusting screw 180 degrees clockwise. (OK)
