260W-10014-SFR

400V Traction Set

88 kW drive set for traction applications
Art.-No.: 1843

KEY FEATURES
▪ Interior permanent magnet synchronous machine
▪ 400V 3-phase motor controller
▪ Water-cooled
▪ Double shaft end with screw flange possible
▪ High efficiency over a wide speed range
▪ Full torque at zero speed

ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de
 260W-10014-SFR Set
400V Traction Set
Table of Content

Section Page
Operating Range 3
Additional Data 5
Certifications 6
Performance Plots 7
Additional Characteristics 8
Technical Drawings 9
Delivery Content 11

To be noted:

The information in this technical data sheet is based on our current

knowledge and experience. Due to the wide range of possible influences
during application, they do not exempt the processor and user from carrying
out their own tests and trials. Although the suitability for a specific
application can be estimated from our information, a legally binding
assurance is by no means possible. Depending on the individual case, we
recommend consultation with us. Any industrial property rights and
applicable laws must be observed by the recipient of our products on his
own responsibility.

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 2 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Operating Range

Characteristic Operation Points1) (cooling as specified on next page)

S1 S2 S2 S2
Feasible operation time ton continuous 30 min 180 sec 30 sec
Torque T 233 250 302 410 Nm
Power P 88 93 106 134 kW
Recuperation power Precu 93 98 112 149 kW
Phase rms-current (AC) Irms 240 252 304 450 A
Battery current (DC) IDC 234 252 283 374 A
Battery voltage (DC) UDC 400 400 400 400 V
Speed n 3600 3600 3370 3130 rpm
Electric frequency fel 300 300 280 261 Hz
Set Efficiency 𝜼𝒕𝒐𝒕 94 94 94 90 %
Maximum Operating Range
Min. Nom. Max.
Torque Tmax - 233 410 Nm
Power Pmax - 88 134 kW
Recuperation power Pmax,Recu - 93 149 kW
Phase rms-current Irms,max - 240 450 A
Battery current (DC) IDC,max - 234 374 A
Battery voltage (DC) Umax 210 400 450 V
Speed nmax - 3600 5300 rpm
Electric frequency fel,max - 300 442 Hz
Power density pgravimetric 1.74 kW/kg

S1 S2
Power Continuous operation Power Short-term operation

On time 𝒕𝒐𝒏

Temperature Temperature

1) Defined Range only valid for a power factor of 1 at DC input

2) Peak rating for max. 30 seconds on time
3) Derating @ 210-250V and >420V
4) Higher speeds available upon request. A detailed discussion of the functional safety concept of the vehicle is required.

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 3 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Operating Range

S9 operating points
Maximum feasible power in % of S1

Prior operating point in % of S1

Unom = 96V
0% 25 % 50 % 75 % 100 %

30 s 150 % 132 % 129 % 127 % 100 %

On time 𝒕 𝒑𝒆𝒂𝒌

80 s 126 % 120 % 118 % 116 % 100 %

180 s 116 % 113 % 111 % 109 % 100 %

Overload capability for subsequent continuous

S9
operation depending on preceding operation

Maximum feasible power in % of S1 for

on time 𝒕𝒑𝒆𝒂𝒌
Power

Prior operating point in % of S1 100 % of S1

Temperature

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 4 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Additional Data

Additional Data
Motor Inverter1)
Weight (w/o cables) 77 8 kg
Rotor moment of inertia 0.077 - kg*m²
Allowed range of ambient temperature -20 … +85 -40 … +90 °C
water/glycol - 50/50
▪ TL 774-D/F
Advised medium
▪ VIN 878389
(OAT Coolants)
▪ MAN 324 SNF
▪ MTL 5048

Cooling Flow rate >8 8 – 12 l/min

Inlet temperature ≤ 601) ≤ 85 °C
Pressure drop > 0.13, max. 0.5 nom. 0.15 bar
Maximum pressure 2 2 bar
Cooling channel volume 1.38 0.5 l
DC link capacitance - 500 μF
Temperature monitoring 1 x KTY84-130 Internal
Rotation direction freely controllable via CAN-Bus
Ports
Power terminals 1 x 2-Phase DC, 1 x 3-Phase AC
Signal connectors CMC, 28-Pin
Cooling connectors inner Ø 12 mm, outer Ø 19 mm
Control and Communication
Slave
Type
Speed/Torque control freely controllable via interface
Symbol/Baud rate 250/500 kBaud/s
CAN Bus
Technology CAN 2.0, J1939 like
Torque Ramp Safety limits can be set in inverter by ENGIRO.
Speed Ramp Safety limits can be set in inverter by ENGIRO.
1) Derating for Tcoolant > 45°C

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 5 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Certifications

Certifications
Motor Inverter
Type approval CE, EN 60034 -
Environmental Prepared for ISO 9227 -
Protection grade ISO 20653 IP6k9k2) ISO 20653 IP67
Vibrations Prepared for ISO 16750-3 Prepared for ISO 16750-3
EMC - CISPR25 (2016), ECE R10 1)
Designed for ISO 26262 up to
Functional safety -
ASIL-C
Custom tariff number 8501 5350 8504 4088
1) Available upon request.
2) Please note that the IP6K9K rating is only valid if the machine is installed with suitable cable glands and an appropriate sealed interface at the drive side of the motor (flange and/or
shaft). Please contact ENGIRO for further questions. / Only applies to SFR Variant /

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 6 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Performance Plots

400V

Simulated Motor Characteristics

solid lines: continuous
dashed lines: maximum

Simulated Generator Characteristics

solid lines: continuous
dashed lines: maximum

210V

Simulated Motor Characteristics

solid lines: continuous
dashed lines: maximum

Simulated Generator Characteristics

solid lines: continuous
dashed lines: maximum

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 7 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Additional characteristics
Simulated nominal power at different Available torque at different coolant
coolant temperatures - Unom = 400V1) temperatures2)

Simulated power and speed Torque over feasible maximum on time, S2

over battery voltage2) operation cycles - 45°C coolant temperature

400V

Simulated Motor Efficiency

Characteristics

1) Motor current is limited by inverter ratings

2) solid lines: continuous; dashed lines: maximum;
Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 8 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Technical Drawings

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 9 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Technical Drawings

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 10 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de

 260W-10014-SFR Set
400V Traction Set
Delivery Content

260W-10014-SFR 400V Set

Item description Article number
Available A: flange B: shaft C: position sensor Component Set
Motor S: single side F: hollow shaft with two
R: resolver 260W_10014_SFR 1843
Variants accessible screw flanges
ENGIRO 400V 3-phase motor controller 240/450A without 400V auxilliary contacts
1586_01 1x
for 260W motor series w/o CAN res.
Amphenol AC port 3 x 50mm² cables with connector; Length: 2000 mm

included in set
1400 1x
UVW
Cables Amphenol DC port 2 x 50mm² cable with connector; Length: 2000 mm 1414 1x
Resolver + Temp. data cable for ENGIRO 260W / 3-phase motor
1666 1x
controller, length: 2m
Cable glands M25 shielded Pflitsch blueglobe IP 69k 1378 3x
Cable lugs DIN 46234 50-8 1333 3x

Data, including specifications, contained within this document are summary in nature and subject to change at any time without notice and are intended for general information
only. Call for latest revision. All brand names and product names referenced are trademarks, registered trademarks, or trade names of their respective holders.

Page: 11 ENGIRO GmbH · Rathausstraße 10 · D - 52072 Aachen

06.2022

Version: 010 Tel. +49 (0)241 56816-0 · E-Mail: [email protected] · www.engiro.de