Scribd
Upload
221 views1 page

VW Pinout TableroMK6

The document outlines the pin configuration for the Celeste dashboard MK6, detailing the functions of each pin, including connections for sensors and indicators. It also provides instructions for powering the dashboard on a workbench by connecting specific pins to positive and negative terminals. Notably, pins are designated for various sensors, indicators, and ground connections, with several pins marked as not used.

Uploaded by

Brian Adrián
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
221 views1 page

VW Pinout TableroMK6

The document outlines the pin configuration for the Celeste dashboard MK6, detailing the functions of each pin, including connections for sensors and indicators. It also provides instructions for powering the dashboard on a workbench by connecting specific pins to positive and negative terminals. Notably, pins are designated for various sensors, indicators, and ground connections, with several pins marked as not used.

Uploaded by

Brian Adrián
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

PIN OUT Ficha Celeste tablero MK6

Pin 1 - Pin 3 from the Fuel Sender


Pin 2 - Pin 4 from the Fuel Sender
Pin 3 - Not Used
Pin 4 - Not Used
Pin 5 - Not Used
Pin 6 - Not Used
Pin 7 - Immobilizer
Pin 8 - Immobilizer
Pin 9 - Pin 6 on Sunroof Control Module
Pin 10 - Not Used
Pin 11 - Oil Temp/Level Sensor
Pin 12 - Not Used
Pin 13 - Not Used
Pin 14 - Not Used
Pin 15 - Brake Pad Wear Indicator
Pin 16 - Terminal 31 (Ground)
Pin 17 - Washer Fluid Low Indicator
Pin 18 - Coolant Low Indicator
Pin 19 - Ambient Temperature Sensor
Pin 20 - Sensormasse (Switched Ground?)
Pin 21 - Not Used
Pin 22 - Not Used
Pin 23 - Not Used
Pin 24 - Not Used
Pin 25 - Hand Brake Indicator
Pin 26 - Brake Fluid Low Indicator
Pin 27 - Oil Pressure Sensor
Pin 28 - CAN High
Pin 29 - CAN Low
Pin 30 - Not Used
Pin 31 - Terminal 15a (Switched Ign)
Pin 32 - Terminal 30a (Constant 12v)

Para encender el tablero en una mesa de trabajo, hay que conectar el pin 16 a negativo, el pin 32 a positivo y luego de
unos 3 segundos conectar el pin 31 a positivo si quieren ver el staging (movimiento de bienvenida de las agujas) si es
que lo habilitaron.

You might also like