IoT-Controller-Installer-User-Manual_1.3.0
IoT-Controller-Installer-User-Manual_1.3.0
User Manual
2022-02-28
IoT Controller Installer 2022-02-28
Contents
1 Introduction 3
1.1 Usage description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
1 Introduction
IoT Controller Installer is designed to install or update IoT components onto the controller hardware.
The application installer requires SSH access to the controller and the operator knowledge about
controller IP address.
SSH operates on port 22 and must be open to the controller sub-network for the application to function
correctly.
To start using the application type the IP Address of the controller, and press the Validate button:
Appropriate action buttons will appear next to the service names listed in bottom part of the main
window.
NOTE This service requires manual post-installation step when upgrading from version 1.xx to
2.xx.
These manual steps are described below, and they aim to reformat the configuration file. It is advisable
to open the controller web interface and check the configuration.
Access the Tag Daemon setting via the Others -> Tag Daemon Settings menu selection:
After opening the Tag Daemon setting page confirm that the newly appearing options fit the user
requirements.