TECHNICAL BULLETIN
Vehicle Model: No: TB-E0144
Date: 27/09/07
A5
Section:ELECTRICAL
Title:
A5 remote control can’t be reprogrammed with a scanner
Affected range:
All A5 vehicles are equipped with the remote control
Description:
A5 remote control can’t be reprogrammed with a scanner according to the
technical bulletin (TB-E0079).
Trouble Analysis:
The possible reasons are as follows:
1. The front ISU doesn’t work;
2. Rear ISU doesn’t work;
3. The key switch doesn’t work;
4. The ignition switch has some troubles;
5. The power of the remote control is poor.
Troubleshooting:
Please see the attachment.
Compiled b y: Checked b y: Approv ed b y:
Sw ord Hu Sam Zhang Frank Ouyang
TECHNICAL BULLETIN - TB-E0144 ENGLISH Page 1
Chery Automobile Ltd 2007
[email protected] Attachment:
Troubleshooting sequence on that A5 remote control can’t be programmed with a scanner
Step Check contents Check result Solution
Disassemble the cathode of the
1
battery, and then assemble it
Connect the scanner（X431）and Yes The trouble is solved
2 reprogram the remote control, and
No Next step
then check whether it is successful
Yes Move to the 7th step
3 Check whether the front ISU works
No Next step
Check whether the front ISU fuse is Replace or tighten
broken or loose (the fuse is located Yes the fuse, and then
4 move to the 2nd step
in the fuse box which is on the
battery) -- please see the fig.1. No Next step
Yes Next step
Check whether all the connectors on
5 the ISU module are connected well on Deal with the
the front ISU No connectors and then
move to the 2nd step
Move to the step 2nd
6 Replace the front ISU
after replacement
Yes Move to the 11th step
7 Check whether the rear ISU works.
No Next step
Check whether the rear ISU fuse is Replace or tighten
broken or loose (the fuse is located Yes the fuse, and then
8 move to the 2nd step
in the fuse box which is on the
battery)—please see the fig. 1 No Next step
Yes Next step
Check whether all the connectors are Deal with the
9
connected well on the rear ISU No connectors and then
move to the 2nd step
Move to the 2nd step
10 Replace the rear ISU module.
after replacement.
Yes Next step
Check whether the key switch works Repair or replace the
11
(please see the fig. 2) No key switch, and then
move to the 2nd step.
Repair or replace the
Check whether the ignition switch ignition switch, and
Yes
12 has some troubles (please see the then move to the 2nd
fig. 3) step
No Next step
TECHNICAL BULLETIN - TB-E0144 ENGLISH Page 2
Chery Automobile Ltd 2007
[email protected] Move to the 2nd step
after replacing the
Check whether the power of the remote Yes
13 battery of the remote
control battery is poor.
control
No Move to the 2nd step
The fuse of the
front ISU (80A)
The fuse of the
rear ISU (50A)
Fig. 1
Fig. 2 fig. 3
Key switch
Ignition switch
TECHNICAL BULLETIN - TB-E0144 ENGLISH Page 3
Chery Automobile Ltd 2007
[email protected]
