Scribd
Upload
17 views1 page

Seven - KSA 01 00 00 - 12 General Requirements

The document outlines construction operations to prevent damage during work, including the secure anchoring of components and compliance with ADAAG for mounting heights. It details procedures for cutting, patching, and core drilling, emphasizing the need for skilled labor, prior approvals, and maintaining fire ratings. Additionally, it stresses the importance of protecting both existing and new work from damage throughout the construction process.

Uploaded by

civil.eng.alessawy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
17 views1 page

Seven - KSA 01 00 00 - 12 General Requirements

The document outlines construction operations to prevent damage during work, including the secure anchoring of components and compliance with ADAAG for mounting heights. It details procedures for cutting, patching, and core drilling, emphasizing the need for skilled labor, prior approvals, and maintaining fire ratings. Additionally, it stresses the importance of protecting both existing and new work from damage throughout the construction process.

Uploaded by

civil.eng.alessawy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

5.

Conduct construction operations so no part of the Work is subjected to damaging


operations or loading in excess of that expected during normal conditions of
occupancy.

D. Anchors and Fasteners: Provide anchors and fasteners as required to anchor each
component securely in place, accurately located and aligned with other portions of the
Work.

E. Mounting Heights: Where mounting heights are not indicated, mount components at
heights compliant with ADAAG when applicable.

F. Cutting and Patching:

1. Employ skilled and experienced installer to perform cutting and patching new or
existing work; restore using new materials.

2. Submit written request in advance of cutting or altering structural or building


enclosure elements.

3. Fit Work tight to adjacent elements. Maintain integrity of wall, ceiling, or floor
construction; completely seal voids.

4. Refinish surfaces to match adjacent finishes.

5. Restore to original or required fire and smoke ratings.

G. Core Drilling: Perform core drilling of structural slabs to accommodate passage of pipe
sleeves, ducts, conduit, or similar utility service lines through floors by trade requiring
opening. Supervise patching holes and verify any core drilled hole through structural
slab is fire stopped with approved firestopping complying with appropriate UL listing.

1. Notify Owner minimum 48 hours in advance of core drilling to obtain approval.


Each day core drilling is required, obtain permission of the Owner and Building
Management prior to commencement of core drilling. Comply with the following
requirements:

a. Demonstrate effectiveness of ground fault safety device in stopping the drill


when the bits contacts metal.
b. Investigate area where core drilling will occur to determine:

1) the exact location of penetration on the ceiling below;


2) the possibility of predictable conduit running through the slab or
potential, foreseeable problems;
3) obtain approval for drill bit coolant from Owner and Architect; and
4) advise Owner and Architect of necessary precautions.

H. Protection of Work: Protect existing and new work and equipment from damage. The
Installing trade is responsible for the protection of its work until the work is complete
and materials and apparatus have been tested and accepted. Obtain directions and
continue protection of work after Installer is no longer on the job. Repair or replace
damaged work.

1. Exercise care to prevent damage to existing Work, equipment, landscaping,


fixtures, utilities, and similar items during construction period until Final

Seven - KSA 01 00 00 - 12 General Requirements

You might also like