Inductive Charger II
Quick facts
With the new Inductive Charger II, Signia keeps your INTUITIVE LEDs:
patients’ inductive charging hearing aids fully powered and
protected. With several enhancements over our previous SINGLE GREEN (CENTER)
version, this high-tech charger was developed based on Plugged into power source
customer feedback and includes several key benefits:
FLASHING ORANGE
Reading status from hearing instruments
• Protective lid
SINGLE ORANGE
• Backwards compatible to previous hearing instruments
0-33% charged
using inductive charging (backwards to Cellion™ primax)
• Fits hearing instruments with custom molds 1 GREEN
34-66% charged
• Auto on/off
• Dehumidifies to keep hearing aids moisture-free 2 GREEN
67%-99% charge
CHARGING DETAILS: 3 GREEN
Full charge
• 30-minute fast charge gives additional 7 hours of use SINGLE ORANGE MOVING ACROSS
Cooling cycle
• Full charge takes 3-4 hours and provides up to 23 hours of
use (without streaming) FLASHING RED
• Charging stops when hearing instruments are fully Error
charged; hearing aids may remain in the charger – Remove hearing instruments from the charger
• Use only power adapter that ships with Inductive Charger II – Unplug charger from power source
• Plug in power adapter BEFORE inserting hearing – Plug charger into power source
instruments (or they may not be detected by the charger). – Reinsert hearing instruments into the charger
Do not unplug power adapter while hearing instruments – If LEDs continue flashing red, contact Tech
are in the charger (battery life may be effected). Support at (800) 766-4500
IMPORTANT NOTES:
• Hearing aids can go in either slot and fit loosely in the
charger
• Though the charger is backward compatible Charge&Go X
must use the new charger
• If necessary, a cooling cycle will begin and charging will
stop (instruments may be warm to the touch); charging
resumes automatically after 5 minutes
Copyright © 2019 Signia GmbH. All rights reserved. 11/19 SI/193XX-19