Essential in Fluent (40 Hours)

Duration
S.No Session Topics Type
(Hours)
INTRODUCTION TO CFD
CFD theory Fundamentals and applications
1 Session 1 Theory/Demo 2.0 Hrs
ANSYS Fluent application
Fluent simulation process
2 Session 2 Exercises included for practice Practicals 2.0 Hrs
ANSYS FLUENT GUI AND SOFTWARE PRELIMINARIES
Solver fundamentals
3 Session 3 Boundary conditions Theory/Demo 2.0 Hrs
CFD solving workflow
Geometry in Design Modeler
4 Session 4 Exercises included for practice Practicals 2.0 Hrs
FLOW MIX AND HEAT TRANSFER (3D)
Meshing using ANSYS Meshing application
CFD Simulation set up: Models, Defining regions, Material definition, Cell Zone conditions
5 Session 5 Theory/Demo 2.0 Hrs
Extracting preliminary results
Coupled solver
Mesh Adaption
6 Session 6 Exercises included for practice Practicals 2.0 Hrs
TRANSONIC FLOW – EXTERNALLY COMPRESSIBLE
CFD Simulation set up: Models, Defining regions, Material definition
7 Session 7 Theory/Demo 2.0 Hrs
Solution
Post Processing
8 Session 8 Exercises included for practice Practicals 2.0 Hrs
MODELING MULTI SPECIES FLOW
1 Case Study
Simulation boundary conditions
9 Session 9 Theory/Demo 2.0 Hrs
Set solution controls
Calculation
Results
10 Session 10 Exercises included for practice Practicals 2.0 Hrs
TURBULENCE MODEL IN FLUENT
Setting up model
Materials and operating conditions
11 Session 11 Theory/Demo 2.0 Hrs
Solution extraction
Convergence modeling
Verification and validation
12 Session 12 Exercises included for practice Practicals 2.0 Hrs
MODELING PERIODIC HEAT FLOW
Creation of zones
Model setup
Material definition
13 Session 13 Cell zone definitions Theory/Demo 2.0 Hrs
Periodicity definition
Boundary conditions
Solution extraction
Advanced post processing
14 Session 14 Exercises included for practice Practicals 2.0 Hrs
RADIATION AND CONVECTION
Model setup
Thermal boundary conditions
15 Session 15 Solution Theory/Demo 2.0 Hrs
Post Processing
Comparing the contour plots
S2S definition and solving
16 Session 16 Exercises included for practice Practicals 2.0 Hrs
TURBULENT FLOW IN HEAT EXCHANGER
Model Setup
17 Session 17 Boundary conditions Theory/Demo 2.0 Hrs
Solving
Post Processing
18 Session 18 Exercises included for practice Practicals 2.0 Hrs
SIPHONING USING MULTIPHASE
Model setup
19 Session 19 Problem setup Theory/Demo 2.0 Hrs
Initialize the flow field
Generate animation
20 Session 20 Exercises included for practice Practicals 2.0 Hrs

Page 1 of 1