Network Analysis and Synthesis

1. Which one of the following is false about LC Network (reactive network?)

a. Contains only inductors and capacitors
b. Real part of Z (and hence Y) is zero
c. No average power loss (lossless network)
d. None
2. ________ method depends on Kirchhoff’s first law.
a. Nodal Analysis
b. Star delta
c. Ohms law
d. None of the above
3. An electric network in which current and voltage values are identified is called _______
process.
a. Networking
b. Network bisection
c. Network analysis
d. None of the above
4. The number of independent equations to solve a network is equal to:
a. The number of chords
b. The number of brunches
c. Sum of the number of branches and chords
d. Sum of the number of branches, chords and nodes
5. ______ in a network are replaced with other network components which provide same
effect same effect.
a. Physical components
b. Resistor
c. Impedance
d. All the above
6. What is the purpose of active components in network circuits?
a. Amplify signals
b. Amputate signals
c. Divert signal
d. Convert signal
7. Thevenin resistance Rth is found
a. By removing voltage sources along with their internal resistances
b. By short circuiting the given two terminals
c. Between any two open terminals
d. Between same short terminals as for Eth
8. ________ is defined as relations between voltage or/and current between input-output
ports.
a. Transfer function
b. Transfer junction
c. Impedance
d. all time
9. The number of independent equations to solve a network is equal to
a. The number of chords
b. The number of branches
c. Sum of the number of branches and chords
d. Sum of number of branches, chords and nodes
10. Which of the following is the passive element?
a. Capacitance
b. Ideal current source
c. Ideal voltage source
d. All of the above
11. An equivalent circuit of Norton represents a network with _____ at a provided frequency.
a. Linear type sources
b. Impedance
c. Both a and b
d. Network
12. Which of the following are the electrical components used in electrical circuits?
a. Switches
b. RLC
c. Transistors
d. All the above
13. What is the purpose of a passive component in a network circuit?
a. Controls current using other electrical signals
b. Controls all the signals alone
c. Transmits from node to node
d. Maintains noise free during transmission
14. For high efficiency of transfer power, internal resistance of the source should be
a. Equal to the load resistance
b. Less than the load resistance
c. More than the load resistance
d. None of the above
15. Which of the following are time varying components?
a. Voltage type controlled amplifiers
b. Variable type equalizers
c. Both a and b
d. None of the above
16. Which one of the following is false about properties of LC function
a. The driving point impedance/admittance of an L-C network is even/odd or odd/even.
b. Both are Hurwitz, hence only simple imaginary zeros and poles on the jw axis.
c. Poles and zeros interlace on the jw axis.
d. Highest power of the numerator and denominator may only differ by 1.
e. none
17. A closed path made by several branches of the network is known as
a. Branch
b. loop
c. Circuit
d. Junction
18. Star configuration has _______ number of ports.
a. 2
b. 3
c. 4
d. Multiple
19. For maximum transfer of power, internal resistance of the source should be ___.
a. Equal to load resistance
b. Less than the load resistance
c. Greater than the load resistance
d. None of the above
20. Which type of circuit connection divides the current or voltage flow in an electric circuit?
a. Series connection
b. Tangential connection
c. Parallel connection
d. All the above
21. Superposition theorem is applicable to linear type networks that has _____ components
a. Independent source
b. Linear dependent type sources
c. Linear passive type elements
d. All the above
22. Which one of the following is true for the removal of conjugate imaginary poles from
Z(s).
a. Removal of conjugate imaginary poles from deriving-point impedance function corresponds
to removal of parallel combination of a capacitor and an inductor from the network.
b. Removal of conjugate imaginary poles from deriving-point impedance function corresponds
to removal of sireies combination of a capacitor and an inductor from the network.
c. Removal of conjugate imaginary poles from deriving-point impedance function corresponds
to removal of parallel and series combination of a capacitor and an inductor from the
network.
d. None of the above
23. Which one of the following is true Removal of a constant from Z(s).
a. Removal of constant from deriving-point function corresponds to removal of a resistor and
capacitor from the network.
b. Removal of constant from deriving-point function corresponds to removal of a resistor
from the network.
c. Removal of constant from deriving-point function corresponds to removal of a inductor and
series resistor from the network.
d. None.
24. According to Kirchhoff’s voltage law, the algebraic sum of all IR drops and e.m.f. in any
closed loop of a network is always
a. Negative
b. Positive
c. Determined by battery e.m.f.
d. Zero
25. If r1, r2, r3 are resistors in a serial circuit then the resistance is of serial circuit is
calculated as _____.
a. 1/(r1+r2+r3)
b. r1+r2=r3
c. r1*r2=r3
d. r1+r2+r3
26. ______ in network theorem relies on Kirchhoff’s 2nd law.
a. Nodal analysis
b. Mesh analysis
c. Ohms law
d. None of the above
27. To determine the polarity of the voltage drop across a resistor, it is necessary to know
a. Value of current through the resistor
b. Direction of current through the resistor
c. Value of resistor
d. E.m.f. in the circuit
28. In a network, source is connected on _________ port.
a. Output
b. Input
c. Both a and b
d. Not connected
29. A passive network is one which contains:
a. Only variable resistance
b. Only some sources of e.m.f. in it
c. Only two sources of e.m.f. in it
d. No source of e.m.f. in it
30. A conductor has a constant current of 5 A. How many electrons pass a fixed point on the
conductor in one minute?
a. 1.87*1021 electrons/min
b. 1.87*10-19 electrons/min
c. 2.13*1021 electrons/min
d. 3.21*1029 electrons/min
31. A network has ________ number of standard ports.
a. 2
b. 3.
c. 4
d. 5
32. The terminals across the source are ____, if a current source is to be neglected.
a. Open-circuited
b. Short-circuited
c. Replaced by a capacitor
d. Replaced by a source resistance
33. For three passive type two terminal components in an electrical network, the transfer function Z(s) of an
inductor is
a. Z(s) = R
b. Z(s) = sL
c. Z (s) = 1/(sC)
d. Z(s) = 1/ R