When It Comes To Your Safety Only The Best Is Good Enough
Fire Fighting Solutions
EGYPT S. A. E. Tel : +20 (2) 2698 9443 / 5 / 6
Gisr El Suez St. Block 109 - Industrial Zone, Fax : +20 (2) 2698 8447
Ismailia Desert Road, Cairo - Egypt PO Box : 2016/11111 Cairo-Egypt
Email:
[email protected] www.bavaria-firefighting.com
MATERIAL SAFETY DATA SHEET Portable Dry Chemical Powder Date :March 2010
In Accordance With Fire Extinguishers, Version : 5
EN 3-10 Clause 5.7 & Directive 1907/EC Stored pressure Operated
2006 EC “REACH” SP - Type Page 1/2
1- Product and Manufacturer Identifications:
Capacities Available as filled with BAVARIA dry chemical powder up to 4, 6, 9, 12 kg.
Working Temperature Range -30°C to 60°C
Testing Pressure 35 bar
Bursting Pressure over 70 bar
Valve Material Special engineered polymers or Brass alloy “ Phoenix, Scout ,Viking, Cosmos & Rotech types”
Discharge Pistol Material Special engineered recyclable polymers
Shell Material Welded steel – DC04 - DIN EN 10130
Extinguishing Agent Mono-Ammonium Phosphate ( MPA ) Based, Dry Chemical Powder
Paint Finish Surface treatment and polyester coating.
Manufacturer Identifications As mentioned above
2 – Composition / Component Data
Chemical characterization Fire extinguishing powder based on ammonium salts and mineral additives
Do not contain dangerous chemicals materials as defined by ordinance on hazardous materials. The
Dangerous components
body, valve & its Components are subjected by internal pressure with non-flammable compressed gas.
Main Components of Dry Chemical Powder CAS-No. EINECS-No.
Mono-ammonium phosphate (based component) 7722-76-1 231-764-5
Ammonium sulphate 7783-20-2 231-984-1
3 – Hazards Identification
- The body, valve & its Components are subjected by internal pressure.
- Users of fire extinguisher must be suitably instructed how to use and made aware of any potential risks from misuse.
- It’s not allowed to make any changes to the fire extinguisher or fittings” as example welding or soldering.
- In case of long lasting contact with fire extinguishing powders, the skin may become dry.
- Don’t direct the pistol of the extinguisher at another person.
- After Use: Mark empty fire extinguisher “EMPTY”, refill after any use, refer to the service agent to refill & recharge it.
Note:Refer to national regulation for periodic maintenance interval; fire extinguisher must not be recharged or serviced except by or with the
consent of manufacturer.
4 – First Aid Measures
- In case of inhalation powder, move to fresh air.
- In case of feeling unwell, call a physician.
- In case of skin contact the powder, wash with soap and water.
- In case of eyes contact the powder, remove contact lens and rinse immediately with plenty of water, also under the eyelids for At least 15
minutes, and in case of eye irritation persists, consult physician.
- In case of ingesting, if swallowed, give small amounts of water to drink.
5 – Fire Fighting Measures
The product itself is not flammable and will not burn.
6 – Accidental Release Measures
Person-related safety precautions Avoid contact powder with eyes and mucous membrane.
Measures for cleaning / collecting Quantities of powder can be removed by vacuum cleaners, dispose off accordance with
local regulation.
Environmental precautions Avoid release powder to inter drains or ground water system.
7 – Handling And Storage
- Fire extinguisher should be stored upright and be firmly secured to prevent falling or being knocked over, It must be only securely fastened by
its holder bracket in such away that it’s not physical damaged by abnormal vibration, movements or fall out.
- Fire extinguisher can be stored in the open, but in such cases, should be protected against extremes of weather and from the dampness of the
ground to prevent rusting.
- Store Fire extinguishers away from heavily trafficked.
- Don’t drop fire extinguishers or permit them to strike each other, Do not drag, slide or roll.
- Keep children away from fire extinguishers.
- Keep the fire extinguisher clean, do not use aggressive cleaning agents, clean it with only slightly wet cloth.
8 – Exposure Controls And Personal Protection
Components with critical values that require monit-
Check that Safety pin and its rivet are still inserted properly.
toring at the work place.
The user shall read the printed instructions on the extinguisher body, trained &
authorized person may use & service the fire extinguisher.
-Stand back at suitable distance when spraying a person who is on fire.
Precautions before use Evacuate and ventilate the area immediately after extinguishing the fire.
The fumes and smoke from any fire may be hazardous and can be deadly.
Warning: persons suffering from over exposure should be immediately removed to area
with fresh air. Apply artificial respiration if necessary& Contact a physician.
When It Comes To Your Safety Only The Best Is Good Enough
Fire Fighting Solutions
MATERIAL SAFETY DATA SHEET Portable Dry Chemical Powder Fire E xtinguishers, Date :March 2010
In Accordance With Stored Pressure Operated Version : 5
EN 3-10 Clause 5.7 & Directive 1907/EC 2006 EC “REACH” SP - Type Page 2/2
8 – Exposure Controls And Personal Protection (con’t)
General protective and hygienic measures - Avoid powder contact with the skin, eyes, foodstuffs and beverage.
Personal protective equipment - In case of high and long-lasting contamination of powder and If required, you can use the
type of mask according the national regulation.
- It’s not a route of ordinary exposure, mono ammonium phosphate is a GRAS “generally
Ingestion recognized as safe “ If amounts of powder are ingested , non specific irritation including
nausea, vomiting, cramps or diarrhea are noticed, consult physician if needed.
Protecting of hands - In case of long lasting contact with fire extinguishing powders, the skin may become dry,
If required use gloves
Environmental exposure controls -No ecological problems; do not flush powder into service water, do not let powder inter
drains; refer to the local & national regulation, see clause12 also.
9 – Physical And Chemical Properties Of Powder Agent
Form Solid, similar to dust Evaluation method
Color White
pH-value 4 – 4.5 (Suspension 10% in water) DIN ISO 787/9
Density Approx. 1.8 g/ml at 20 °C
Melting range Approx. >200 °C
10 – Stability And Reactivity
void powder agent contact with strong alkali, strong acids, also avoid the mixing with
A
Avoiding conditions
other extinguished agent as strong alkali or mixing with BC fire extinguishing powder.
11 – Toxicological Information
LD-50 rat (oral) > 2000 mg/kg
12 – Ecological Information
- Powder produced by these extinguishers is rather large and indoors can impair your vision. It will also cover everything in the area in a very fine
dust which can cause damage to sensitive electrical equipment, such as computers.
- No ecological problems are to be expected when the product is handled and used with due care attention, fertilizing effect is possible.
13 - Disposal Consideration
Product:
-Fire extinguishers are disposing through recognized company according to local & national legislation once it has been completely depressurized and
emptied; treat empty containers as they were full.
- The fire extinguisher is under pressure, don’t subject it to external force, damaged, the corroded tanks, fittings, cartridges or cylinders must be
depressurized by authorized person.
- Residues, plastic components and fire extinguishing powders have to be supplied to an approved recycling company refer also to the local and
national legislation.
Packing:
Recyclable cardboard and plastic Packs
14 – Transport Information
It is not dangerous goods in the meaning of ADR/RID and not classified as dangerous in the meaning of waterways or sea transport. , product is
powder-based and internally pressurized with non flammable propellant gas.
15 – Regulation Information
Designation according to EG guidelines:
Product powder -based is not subject to identification regulations under EC. Directives and the “Ordinance on Hazardous Materials”
German regulations:
Wassergefährdungsklasse “ Water hazard class” : class 1 (slightly polluting substance)
16 – Other Information
Product described in this safety data sheet only used for fire fighting extinguishing purposes.
The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of
these data or the results to be obtained from the use thereof. BAVARIA EGYPT assumes no responsibility for injury to the vendee or third persons
proximately caused by the material if reasonable safety procedures are not adhered to as stipulated in the data sheet. Additionally, BAVARIA EGYPT
assumes no responsibility for injury to vendee or third persons proximately caused by abnormal use of the material even if reasonable safety proced-
dures are followed. Furthermore, vendee assumes the risk in his use of the material.
Existing laws and regulations have to be observed by the consignee in his own responsibility
EGYPT S. A. E.
