REPLACEMENT PARTS GUIDE

670 P Motor Grader (PIN: 1BZ670GA_ _C_00001— )

670 P Motor Grader (PIN: 1BZ670GA_ _D_00001— )

ENGINE AIR FILTER ELEMENT

(PRIMARY FILTER)
1 PRIMARY AND FINAL FUEL FILTER KIT
AT175223 9
RE525523
Interval (hrs) - As Required.
Interval (hrs) - 500.
ENGINE AIR FILTER ELEMENT (SECONDARY
FILTER) HYDRAULIC OIL FILTER
AT175224
2 10
AT367840
Interval (hrs) - As Required. Interval (hrs) - 2000.

CAB FRESH AIR FILTER FUEL TANK BREATHER

11
AT191102 3
H216169
Interval (hrs) - As Required. Interval (hrs) - 1000.
AXLE OIL FILTER
CAB RECIRCULATION AIR FILTER
12 AT335492
AT307501 4

2 1 Interval (hrs) - 2000.

Interval (hrs) - As Required. 4
3
5
10
9 11 12
6 7
8 14 13 ENGINE OIL FILTER
ENGINE ROCKER ARM COVER GASKET 16

15 13
DZ118283
R527884 5

Interval (hrs) - 500.

Interval (hrs) - 2000.
TRANSMISSION OIL FILTER
HYDRAULIC TANK BREATHER FILTER 14
AT335492
AT101565 6
Interval (hrs) - 2000.
Interval (hrs) - 2000.
REAR AXLE BREATHER FILTER
ENGINE CRANKSHAFT DAMPER
15 AT101565
RE57604 7
Interval (hrs) - 2000.
Interval (hrs) - 4500.
AUXILIARY FUEL FILTER (IF EQUIPPED)
6WD HYDRAULIC OIL FILTER (IF EQUIPPED) AT365869
16
AT367840 8
Interval (hrs) - 500.
Interval (hrs) - 2000.

CLICK PART NUMBER TO BUY

Nov 2023. Release Date. *See operator’s manual for addional details.
 OIL AND CAPACITIES INFORMATION
670 P Motor Grader (PIN: 1BZ670GA_ _C_00001— )
670 P Motor Grader (PIN: 1BZ670GA_ _D_00001— )

Part Description Qty or capacity Change Interval In Hours

John Deere Plus-50™ II Engine Oil2 28.0 L (7.4 gal) 500

John Deere Hydrau™ Hydraulic System Oil2 53.0 L (14.0 gal) 4000

John Deere Hy-Gard™ 6WD Hub Oil2(if equipped) (each) 7.2 L (1.9 gal) 1000

John Deere Hy-Gard™ Transmission and Axle Oil2 66.4 L (17.5 gal) 2000

John Deere Hy-Gard™ Tandem Oil2(each) 74.0 L (19.5 gal) 4000

John Deere Hy-Gard™ Circle Gear Case Oil2(standard circle) 5.7 L (1.5 gal) 2000

John Deere Hy-Gard™ Circle Gear Case Oil2(premium circle) 6.4 L (1.7 gal) 4500

John Deere Cool-Gard™ II Pre-Mix 48.5 L (12.8 gal) 6000

Fluid Analysis Kits

Diesel Engine Oil 1 250

Transmission Oil 1 500

Axle Oil 1 500

Tandem Oil 2 500
Hydraulic Oil 1 500
6WD Hub Oil (if equipped) 2 500
Diesel Fuel 1 500
Engine Coolant 1 500
Perform initial service once after the first 500 hours of operation.
1

2
See operator's manual for recommended oil type and oil viscosities based on operating temperatures.
3
Based on fluid analysis results, intervals may need to be adjusted for operating conditions. Consult a Local John Deere dealer.
Plus-50 is a trademark of Deere & Company
Hydrau is a trademark of Deere & Company
Hy-Gard is a trademark of Deere & Company
Cool-Gard is a trademark of Deere & Company
Nov 2023. Release Date. *See operator’s manual for addional details.
 Service intervals
670 P Motor Grader (PIN: 1BZ670GA_ _C_00001— )
670 P Motor Grader (PIN: 1BZ670GA_ _D_00001— )

As Required

□ Clean cooler cores □ Inspect accessory belt and belt tensioner spring

□ Clean and tighten battery terminals □ Replace engine air intake filter elements
□ Clean battery compartment □ Drain fuel tank sump

□ Replace cab fresh air and cab recirculation filters □ Drain primary fuel filter and water separator

□ Lubricate circle pinion (standard circle) □ Drain auxiliary fuel filter and water separator (if equipped)

□ Check tire pressure □ Check camera (if equipped)

□ Check blade circle and draft frame wear inserts (standard circle) □ Transmission control unit (TCU) calibration

□ Check blade lift cylinder sockets □ 6WD controller calibration (if equipped)

□ Lubricate saddle locking pin holes □ Cross slope sensors calibration (if equipped)

□ Blade side shift wear insert adjustment □ Hydraulic valves calibration (if equipped)

Every 10 Hours or Daily

□ Check hydraulic tank oil level □ Check engine oil level

□ Check transmission oil level □ Check engine coolant surge tank level

Every 50 Hours

□ Lubricate frame hinge pivots □ Lubricate front axle steering pin

□ Lubricate lift cylinders □ Lubricate tie rod ends

□ Lubricate draft frame ball □ Lubricate steering cylinders

□ Lubricate dozer blade (if equipped) □ Lubricate midmount scarifier (if equipped)

□ Lubricate front axle oscillation pin □ Lubricate circle side shift cylinder

□ Lubricate front axle lean pivot casting pins □ Lubricate saddle locking pin

□ Lubricate front axle lean bar pivot

Every 250 Hours

□ Check hybrid battery electrolyte level (if equipped) □ Take engine oil sample

Initial Service—Every 500 Hours1

□ Replace axle oil filter □ Replace transmission oil filter

Nov 2023. Release Date. *See operator’s manual for addional details.
 Service intervals
Every 500 Hours

□ Check tandem oil level □ Replace primary fuel filter and water separator

□ Check axle oil level □ Replace auxiliary fuel filter and water separator (if equipped)

□ Drain and refill engine oil and replace filter □ Take hydraulic oil sample

□ Drain and refill engine oil (quick service) (if equipped) □ Take transmission oil sample

□ Lubricate tandem pivots □ Take axle oil sample

□ Check circle gear case oil level (standard circle) □ Take tandem oil sample

□ Check brake accumulator □ Take 6WD hub oil sample (if equipped)

□ Replace final fuel filter □ Take engine coolant sample

□ Check 6WD hub oil level (if equipped) □ Take diesel fuel sample

□ Lubricate circle ring gear (premium circle)

Every 1000 Hours

□ Drain and refill 6WD hub oil (if equipped) □ Check coolant condition

□ Adjust front wheel bearings (standard axle only) □ Replace fuel tank breather

□ Check engine air intake hoses

Every 2000 Hours

□ Drain and refill axle oil □ Replace axle oil filter

□ Drain and refill transmission oil □ Replace hydraulic oil filter

□ Drain and refill transmission oil (quick service) (if equipped) □ Replace transmission oil filter

□ Replace rear axle breather filter and hydraulic tank breather filter □ Replace 6WD hydraulic oil filter (if equipped)

□ Drain and refill circle gear case oil (standard circle) □ Clean engine crankcase ventilation tube

□ Check and adjust engine valve lash

Every 4000 Hours

□ Drain and refill hydraulic tank oil □ Drain and refill tandem oil

□ Drain and refill hydraulic tank oil (quick service) (if equipped) □ Clean transmission pump inlet screen

□ Drain and refill circle gear case oil (premium circle)

Every 4500 Hours

□ Replace engine crankshaft damper

Every 6000 Hours

□ Drain and refill cooling system □ Drain and refill cooling system (quick service) (if equipped)

1
Perform initial service once after the first 500 hours of operation

Nov 2023. Release Date. *See operator’s manual for addional details.