Last Revised: 1/1/25 - special thanks to flsdiver on f150forum.
com with spreadsheet generation/formatting
** Below: ignore whatever you have where the x's are and just write the non-x value in the correct position ** Note: module BCM=BdyCM in FORScan
Feature Name Module Address Value change Notes
IPMA 706-02-02 xxxF CExx xx--
Enable Cameras at Speed APIM 7D0-01-01 xxxx xxxx FD--
APIM 7D0-01-04 xxxx FDxx xx-- use FF if you have 1-pedal drive
Enable OffRoad (Rock Crawl, Mud/Ruts, and Deep
Snow/Sand) Front Camera at Speed IPMA 706-02-02 xxxx xx03 xx--
tricks Auto Start/Stop into thinking a steering event is happening at a stop so ASS
Auto Start/Stop Disabled PSCM 730-03-01 xxxx xxxx 00-- never happens
HVAC 733-01-05 xxxx x0xx xx-- optional - disables Auto Stop/Start switch from illuminating
Double Horn Honk disable BCM 726-63-02 xxx0 xxxx xx-- disables double honk when exiting running vehicle
If your default is 4 change to 0, if default is 5 change to 1 AND disconnect PACM
Disable Pedestrian Alert Speaker IPC 720-09-02 x*xx xx-- under the glove box according to this video: https://youtu.be/0K9M7hZQTec
Tire Size - requires PCM/TCM Relearn procedure after BCM 726-15-01 xxxx xxxx AB-- First two digits of tire circumference in MM encoded in hex
change (unconfirmed if available in newest FORScan Last two digits of tire circumference in MM encoded in hex
version) BCM 726-15-02 CDxx xx--
click here for Spart's tire size calculator
Fogs on when high beams are on (aka Bambi Mode) BCM 726-39-02 xxx0 xxxx xx--
Power Point Timeout Duration (in seconds converted to 0001=1 second
BCM 726-57-01 ABCD xxxx xx--
hex) DeltaNu1142's power point timeout calculator
xxxx 00xx xx-- disabled (always on)
Power Point Timeout Configuration BCM 726-57-01
xxxx 01xx xx-- enabled (default - use timeout duration above)
Keyfob Panic Button BCM 726-62-01 x*xx xxxx xx-- 0=disabled, 1=2 clicks, 2=one click (default)
Keyfob Panic Alarm BCM 726-01-02 xxxx xxx* xx-- 0=lights & horn (default) 1=lights only
Keyfob Car Finder - (clicking lock twice honks horn) BCM 726-24-02 xxxx xxxx **-- 1=enabled, 0=disabled
Front Turn Bulb Outage Detection BCM 726-40-02 **xx xxxx xx-- 00=No Outage 01=Outage - set to no outage when upgrading to LED
Rear Turn Bulb Outage Detection BCM 726-44-02 **xx xxxx xx-- 00=No Outage 01=Outage - set to no outage when upgrading to LED
Front Turn LED Outage Detection BCM 726-40-02 xx** xxxx xx-- 00=No Outage 01=Outage
Rear Turn LED Outage Detection BCM 726-40-02 xxxx **xx xx-- 00=No Outage 01=Outage
Enable digital temps for engine & transmission on 12" E5 (turbo & trailer brake controller), 65 (turbo & no TBC), A5 (non-turbo & TBC),
digital cluster only IPC 720-07-01 xxxx x**x xx-- 25 (non-turbo & no TBC)
Disable driver & passenger seatbelt minder IPC 720-01-01 xxxx xx0x xx--
Disable Auto Engine Idle Shutdown of 30 mins IPC 720-01-01 x*xx xxxx xx-- subtract 8 from your default value (if default is F, change to 7)
Prevent headlamp switch from defaulting to Auto
position BCM 726-74-01 xx01 xxxx xx-- headlamp switch will revert to last position used on next startup
Disables door ajar chime IPC 720-01-02 xx*x xx-- see IPC spreadsheet to disable EIOCM
Disable key-in ignition chime IPC 720-02-01 xx*x xxxx xx-- subtract 8 from current value (if E change to 6)
DDM 740-03-16 xxxx xxxx 01-- click here for an explanation of regular autofold vs Lincoln autofold
Mirrors - Lincoln Autofold PDM 741-03-16 xxxx xxxx 01-- Note: the tradeoff of using Lincoln Autofold is that puddle lights won't work
APIM 7D0-09-01 xxxx xxAx xx--
DDM 740-06-02 xxxx xxxx 01-- Optional: to add Global Open/Close to Sync 4 Settings menu set this in APIM:
PDM 741-06-02 xxxx xxxx 01-- 7D0-09-01- xxxx xExx xx--'
DDM 740-06-03 01xx xxxx xx--
Global Windows Open/Close
(driver/pass windows only) PDM 741-06-03 01xx xxxx xx-- To roll down windows press unlock button on fob and then press again and hold
BCM 726-11-02 xx01 xx01 xx-- To roll up windows press lock button on fob and then press again and hold
BCM 726-22-01 xxxx xxxx 01--
BCM 726-22-02 xxxx xxxx 01--
DDM 740-06-02 xxxx xxx1 01-- Optional: to add Global Open/Close to Sync 4 Settings menu set this in APIM:
PDM 741-06-02 xxxx xxx1 01-- 7D0-09-01- xxxx xExx xx--'
2024 Global Windows Open/Close
(driver/pass windows only)
Last Revised: 1/1/25 - special thanks to flsdiver on f150forum.com with spreadsheet generation/formatting
** Below: ignore whatever you have where the x's are and just write the non-x value in the correct position ** Note: module BCM=BdyCM in FORScan
Feature Name Module Address Value change Notes
2024 Global Windows Open/Close
(driver/pass windows only) BCM 726-11-02 x1xx x1xx xx-- To roll down windows press unlock button on fob and then press again and hold
BCM 726-22-01 xxxx xxxx 01-- To roll up windows press lock button on fob and then press again and hold
BCM 726-22-02 xxxx xxxx 01--
BCM 726-31-01 xxxx xx01 xx-- See this post if you don't know the factory code
Keypad Enable (wired keypad) optional - adds door keypad code to Sync settings use 6 if you have ambient
APIM 7D0-01-02 xxxx x*xx xx-- lighting or 2 if you don't
Keyfob Tailgate Release - disable BCM 726-61-01 xxxx xxxx 00--
BCM 726-42-01 x2x2 xxxx xx--
DRLs - full brightness set at about 60% (3C hex) thru 75% (4B hex) use lowest value you can before
BCM 726-38-01 xxxx **xx xx-- flickering appears
DRLs - include parking lights BCM 726-38-01 xxxx xxxx 01-- will turn on rear tails with DRLs
DRLs - allow fog lights BCM 726-38-02 00xx xxxx xx-- allows fogs to be turned on with DRLs
Disable Fake Engine Noise ACM 727-01-01 xxxx xxxx 0x--
Enable 75th Anniversary Splash Screen APIM 7D0-03-01 xxxx 24xx xx-- Requires Sync ver 22012 or higher - reset APIM in FORScan after either/both
Enable Unreal Sync Theme APIM 7D0-02-03 xxxx xxx1 xx-- changes
Enable Climate Bar at the bottom of Sync screen APIM 7D0-02-02 xxx* xxxx xx-- use 2 for non-hybrid or 6 for hybrid - requires Unreal theme above
Enable Heated Steering Wheel on climate bar above APIM 7D0-02-01 xxxx *xxx xx-- see APIM spreadsheet for your value
Enable Cooled and/or Heated seats to climate bar above APIM 7D0-02-01 xxxx x*xx xx-- if you have heated & cooled seats then use A
Enable Lightning F150 Splash Screen APIM 7D0-03-01 xxxx 1Fxx xx--
Enable Oil Life in Sync Settings, Vehicle APIM 7D0-10-01 x8xx xxxx xx--
APIM 7D0-09-01 x1xx xxxx xx--
reset APIM in FORScan after these changes
APIM 7D0-09-03 xxCx xxxx xx--
IPMA 706-01-01 xxxx xxx9 xx--
SCCM 724-04-01 xxx4 xxxx xx--
Glare Free Menu (replaces Auto High Beam in APIM) IPC 720-01-01 xx8x xxxx xx--
IPC 720-10-01 xxxx xxx3 xx--
Note: do all the changes to the right except but choose HCM 734-01-01 xxxx xx01 xx--
the appropriate selection for 734-01-04 HCM 734-01-02 x3xx xxxx xx--
HCM 734-01-04 xx53 4E-- * use this for short bed, no onboard scales / ccd
HCM 734-01-04 xx56 D1-- * use this for short bed with scales / ccd or Raptor
HCM 734-01-04 xxD9 88-- * use this for long bed no scales / ccd
HCM 734-01-04 xxDC 17-- * use this for long bed with scales / ccd
Removes black box on reverse camera that says "full If your current value is 0 then change to 1, 2 change to 3, 4 change to 5, 6
view not available" APIM 7D0-02-02 xxx* xxxx xx-- change to 7 Note: reset APIM after the change
ADAS - Advanced Driver Assist Systems
Disable BlueCruise and enable Traffic Jam Assist
(settings for normal Adaptive Cruise Control) IPMA 706-01-01 xxx8 xxxx 8x-- enables Traffic Jam Assist & disables Highway Assist
Trailer Side View - shows corresponding camera view IPMA 706-01-02 3xxx xxxx xx--
alongside of vehicle when turn signal is applied with trailer
connected Note: requires newest 12/23 ipma update APIM 7D0-02-03 xxxx x8xx xx-- adds Trailer Side View toggle under Driver Assistance
Disable Active Air Dam PCM 7E0-162-02 xxxx xxxx x1--
BCM 726-89-02 x1x1 x1x1 x1--
Walk Away Lock (2024 only) - locks the vehicle when you
walk away BCM 726-90-01 xxx1 xxxx xx--
APIM 7D0-09-05 xxxx 8xxx xx--
Walk Away Lock Audible Feedback (2024 only) - sounds BCM 726-89-01 x1x1 x1x1 x1--
the horn when doors are locked with the Walk Away Lock
enabled
Last Revised: 1/1/25 - special thanks to flsdiver on f150forum.com with spreadsheet generation/formatting
** Below: ignore whatever you have where the x's are and just write the non-x value in the correct position ** Note: module BCM=BdyCM in FORScan
Feature Name Module Address Value change Notes
Walk Away Lock Audible Feedback (2024 only) - sounds
the horn when doors are locked with the Walk Away Lock BCM 726-90-01 x1xx xxxx xx--
enabled
APIM 7D0-09-05 xxxx Cxxx xx--
BCM 726-20-01 x1x1 x1x1 x1--
BCM 726-27-01 xxxx xxxx x1--
Auto Relock - if you hit the unlock button on the fob and do
not open a door within the timer it will lock the truck BCM 726-58-02 xxx* xxxx xx-- Use this on 2021-23 duration: 1=30 seconds, 2=45 secs
BCM 726-58-02 x*xx xxxx xx-- Use this on 2024 duration: 1=30 seconds, 2=45 secs
APIM 7D0-09-01 xx3x xxxx xx-- optional - adds Autorelock to settings, vehicle, locks
Enable Extra Brake Light Wire Circuit for Camper Shell
(2021-23) BCMC 6F0-01-03 xxx1 -- see this thread for description
BCM 726-38-01 xxxx xxxx x1-- DRL_IncludeParklamps_Cfg
BCM 726-38-02 xxx0 xxxx xx-- DRL_WithTurn_Cfg
Low Beams & Parking Lamps as DRL (2024) - see this
post for pics BCM 726-41-02 xxx1 xxxx xx-- LowBeam_Cfg
BCM 726-42-02 xxx1 x1xx xx-- LF/RF_Low_Beam_Ckt_Usage_Cfg
BCM 726-43-02 xxxx xxx1 xx-- DRL_OnWithParkLampsOn_Cfg
BCM 726-38-01 xxxx xxxx 01-- Daytime Running Lights (DRL) Include Parklamps Config
2024 Raptor (marker lights on with DRL) BCM 726-43-02 xxxx xx01 xx-- Daytime Running Lights (DRL) On With Park Lamps On Config
BCM 726-87-01 xx00 xxxx xx-- Daytime Running Lights (DRL) Suppress License Config
