Scribd
Upload
217 views3 pages

Practical Assessment Install and Assemble Electronic Circuits

This document outlines a practical assessment for Electrical and Electronics Engineering Level 6 students at Kabete National Polytechnic, focusing on installing and assembling electronic circuits. The assessment includes tasks such as mounting a multivibrator circuit, measuring voltages at specific test points, displaying waveforms using an oscilloscope, and conducting continuity and polarity tests. Students are provided with necessary materials and instructions for completing the assessment within a 3-hour timeframe.

Uploaded by

Kennedy Muthoni
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
217 views3 pages

Practical Assessment Install and Assemble Electronic Circuits

This document outlines a practical assessment for Electrical and Electronics Engineering Level 6 students at Kabete National Polytechnic, focusing on installing and assembling electronic circuits. The assessment includes tasks such as mounting a multivibrator circuit, measuring voltages at specific test points, displaying waveforms using an oscilloscope, and conducting continuity and polarity tests. Students are provided with necessary materials and instructions for completing the assessment within a 3-hour timeframe.

Uploaded by

Kennedy Muthoni
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 3

©2025 KNP

THE KABETE NATIONAL POLYTECHNIC

ELECTRICAL AND ELECTRONICS ENGINEERING LEVEL 6


UNIT CODE: 0714 551 15A

CLASS: EET600/J24

Install and Assemble Electronic circuits

April 2025

PRACTICAL ASSESSMENT

Time: 3 HOURS

INSTRUCTIONS TO CANDIDATE:
1. Do not write on the question paper.
2. A separate plain paper will be provided.
3. Return this paper to assessor at the end of assessment.

This tool consists of three (3) printed pages.


Candidate should check the question paper to ascertain that
all the pages are printed as indicated and that no questions are missing.

Page 1 of 3
©2025 KNP

Figure 1 shows a multivibrator circuit. You are provided with the following materials to carry out
the given tasks.
- Oscilloscope
- Multimeter
- Breadboard
- 12 V dc power supply
- 555 Timer IC
- Ceramic capacitor :0.01 𝜇𝐹 𝑎𝑛𝑑 0.1 𝜇𝐹
- Resistors: 𝑅1 = 2 𝑘Ω, 𝑅2 = 10 𝑘Ω, 𝑅3 = 1 𝑘Ω 𝑎𝑛𝑑 𝑅4 = 1 𝑘Ω
TASK 1:
Mount the circuit as shown in figure 1 on the breadboard.
TASK 2:
Power the circuit and measure the voltages at the following test points.
i. 𝑇𝑃1
ii. 𝑇𝑃2
iii. 𝑇𝑃4
TASK 3:
i. Use an oscilloscope to display the waveform at test point 𝑇𝑃3
ii. Draw the output waveform at 𝑇𝑃3
TASK 4:
Carry out the following tests and compile a report.
i. Continuity test
ii. Polarity test

Page 2 of 3
©2025 KNP

Figure 1

THIS IS THE LAST PRINTED PAGE.

Page 3 of 3

You might also like