Nov.
2020
BANNOH 5000 No. 6189M
M2-42240A
（BN 5000 ）
BANNOH 5000 is a multi-purpose solvent free epoxy which provides excellent physical and
anti-corrosive properties. For ships it is ideally suited as a universal primer for most areas.
ProductID:M2-42240A
TECHNICAL DATA
Type Solvent free epoxy coating
RecommendedUse Anti-corrosive paint for ship’s hull, exposed decks, superstructures, ballast water
tanks, steel structures , immersed areas etc.
Information Mixing Ratio : Base : Hardener = 4 : 1 [by volume]
Colour : Light grey, Grey, Cream, Brown
Flash Point : Base = 141, Hardener = 145 [˚C]
Density : 1.54 [g/mL]
Volume solids (VS) : 100 [volume %]
VOC : 0 [g/L]
Coverage(Theoretical): 0.32 [L/m2]
Film Thickness : WET 320 [microns]
DRY 320 [microns]
(DFT 320microns) 10 C
o o
15 C
o
20 C
o
30 C
Drying Time Set-to-touch - 16hrs. 9hrs. 5hrs.
Hard Dry - 28hrs. 16hrs. 10hrs.
Painting Interval Min - 28hrs. 16hrs. 10hrs.
Max * - 14days 14days 14days
Pot Life - 90mins. 80mins. 60mins.
Dry to Launch Min - 5days 4days 3days
Condition Method of Application : Airless spray, Brush, Roller
of Weather : Temperature:Minimum 10 ˚C, Humidity:Maximum 85 %RH, Dew
Application Point +Minimum 3 degC
For Airless Spray : Viscosity : 2.5 - 3.0 Pa･s
Tip No. : (GRACO)415 - 731
Paint Output Pressure: Min.23.5[MPa]
Spray Speed : 60 - 80[cm/sec]
Thinner : EPOXY THINNER A (for cleaner)
Preceding Coats : CERABOND 2000, EPICON ZINC RICH PRIMER B-2, etc
Subsequent Coats : BANNOH 1500R Z, UNYMARINE, EPICON FINISH HB, etc.
Packaging Two pack product
Notes 1.We recommend storage should be on a cool environment, preferable within 15˚C to 25˚C
avoiding direct sunlight. Storage outside this range could shorten a shelf life.
2.For application in lower temperature conditions , it is recommended to facilitate the
application by means of safely heating the paint and air. A viscosity adjustment may be made
by heating each component and mixture.
3.Agitate Base with a power agitator until it is turned homogeneous, and then combine entire
contents of Hardener with Base and mix thoroughly with power agitator.
4.This product can be applied by normal airless pump, and for low temperature application, a
line heater can be used together with normal airless spray.
5.Density, VOC and VS are calculated from the formula without thinning. Values may vary
depending on color, manufacturing process, local regulations, etc.
This product should be used only by professional applicators. Consult the current Chugoku Marine Paints Safety Data Sheets. Follow all local
or national health, safety and environmental regulations. Observe all safety labels on packaging and containers. Take precautions against
possible risks of fire or explosions as well as protection of the environment. Apply only at ventilated areas. Handle with care.
This data sheet contains the best and latest of our knowledge on the date of issue on our laboratory test in Japan and practical application
experience, and subject to change without notice. Since the paints are used under unexpected circumstances in some cases, guarantee can
not be given except on the quality of those paints themselves.
