Printed Pages:02 Sub Code: KOE047

Paper Id: 238141 Roll No.

B.TECH
(SEM IV) THEORY EXAMINATION 2022-23
ANALOG ELECTRONICS
Time: 3 Hours Total Marks: 100
Note: Attempt all Sections. If require any missing data; then choose suitably.

SECTION A

1. Attempt all questions in brief. 2 x 10 = 20

(a) What do you understand by DC and AC analysis.
(b) Define stability factor for a biasing scheme.
(c) Define the efficiency of power amplifiers.
(d) If differential mode gain of a differential amplifier is 1000 and common mode
gain is 10, calculate the CMRR in decibel for it.
(e) If open loop gain of an amplifier is 2000 and feedback factor of the system is .02,
calculate the closed loop gain for negative feedback
(f) Explain the concept of virtual short in operational amplifier.
(g) List the properties of an ideal operational amplifier.
90

2
(h) Define frequency stability in oscillators.

13
(i) Differentiate between Comparator and Schmitt Trigger.
_2

2.
(j) What is meant by Filter.
P2

24
3E

5.
SECTION B

.5
P2

2. Attempt any three of the following: 10x3=30

17
Q

(a) Describe emitter follower. Derive expression for input & output resistance.
|1
(b) Discuss the advantages of negative feedback in detail with explanation.
(c) Explain the working of a tank circuit. Also derive the frequency of oscillation
1

and condition of gain to get sustained oscillations for Colpitts oscillator.

:2

(d) Describe following application of Op-amp

26

(i) Precision rectifier (ii) Phase Changer (iii) Averaging

:

(iv) Non-inverting summer

13

(e) What is Super Diode? Describe the working of full wave precision rectifier
3

giving its transfer characteristic.

02
-2

SECTION C
08
3-

3. Attempt any one part of the following: 10x1=10

|0

(a) Define stability factor. What is meant by transistor-biasing. Describe voltage

divider bias circuits.
(b) Describe MOSFET internal capacitances. Draw the high frequency equivalent
circuit model for the MOSFET.

QP23EP2_290 | 03-08-2023 13:26:21 | 117.55.242.132

4. Attempt any one part of the following: 10x1=10
(a) Describe an amplifier using shunt – series feedback, derive the expression for
the output resistance with feedback and show that due to negative feedback, the
output resistance reduces below its value without feedback.
(b) Describe Class B operation giving its circuit and transfer characteristics curve.
Also obtain its power conversion efficiency.

5. Attempt any one part of the following: 10x1=10

(a) Describe the operation of RC phase shift oscillator giving its neat diagram. Also
drive expressions for its frequency of operation and gain for the sustained
oscillations.
(b) With neat diagram explain the generation of square wave using Op-amp and
calculate its total time period.

6. Attempt any one part of the following: 10x1=10

(a) What are the desirable characteristics of current mirror circuits. Draw the simple
BJT current mirror and obtain the expression for current transfer ratio using
matched transistors.
(b) Describe the operation giving circuit of BJT differential amplifier. Obtain
expression for input differential resistance and differential voltage gain.
90

2
13
7. Attempt any one part of the following: 10x1=10
_2

2.
(a) What is a Filter circuit. Give classification of filter circuit on the basis its
P2

24
frequency response. Design a second order High Pass Filter to provide a Cut-off
3E

frequency of 1 kHz and Pass band gain of 2

5.
(b) Define the following with reference to filter :

.5
P2

(i) Pass Band

(ii) Stop Band 17
Q

|1
(iii) Roll-off rate
(iv) Cut-off frequency
1
:2
: 26
13
3
02
-2
08
3-
|0

QP23EP2_290 | 03-08-2023 13:26:21 | 117.55.242.132