III SEM ANALOG CIRCUITS UNIT WISE QUESTION BANK
2023-2024
UNIT-1 BT LEVEL : III
Short Type Questions
1. What are operating regions of a transistor?
2. What is biasing?
3. Explain the need of biasing?
4. List out different types of biasing methods.
5. Define Stability factor.
6. Draw the H-parameter model of a transistor.
7. Sketch the frequency response of CE Amplifier.
8. Define bandwidth.
9. What is the use of coupling capacitor in amplifiers?
10. What is the use of bypass capacitor in amplifiers?
Long Type Questions
1. Compute the stability factor of BJT using potential divider bias.
2. Illustrate bias compensation technique using diode.
3. Sketch the DC Load line of CE Amplifier and find its Operating point Q.
4. Compute the stability factor of BJT using Fixed Bias.
5. Determine AV, AI, RI, R0 of CE Amplifier using approximate H-parameter model.
6. Determine AV, AI, RI, R0 of CB Amplifier using approximate H-parameter model.
7. Determine CE Amplifier with emitter resistance using approximate H-parameter model.
UNIT-2 BT LEVEL: IV
Short Type Questions
1. Draw Small Signal model of FET Amplifier.
2. Define amplification factor.
3. Define Drain resistance.
4. Define transconductance.
5. What are types of biasing techniques in FET?
6. Why common drain amplifier is called as Source Follower.
7. Write the relation between µ.gm, rd.
8. What are the advantages of FET over BJT?
9. Compare CS, CD, CG amplifiers.
10. Write the advantages of MOSFET.
Long Type Questions
1. Analyze Fixed Bias Circuit using JFET Amplifier
2. Analyze the Self Bias JFET amplifier.
3. Analyze Voltage Divider Bias using CS JFET Amplifier
4. Draw the CS FET amplifier equivalent circuit looking into the drain and find its gain and
output impedance.
5. Draw the CD FET amplifier equivalent circuit and find its gain and output impedance.
6. Draw the CG FET amplifier equivalent circuit and find its gain and output impedance.
7. Analyze the MOSFET Amplifier with resistive Load and find voltage gain, Input
Impedance and output impedance.
UNIT-3 BT LEVEL: IV
Short Type Questions
1. What are the methods of coupling schemes used in multistage amplifiers?
2. What are the types of distortions in amplifiers.
3. Two amplifiers having gain 20 dB and 40 dB are cascaded. Find the overall gain in dB?
4. What are the advantages of Darlington connection?
5. What are the techniques employed in improving input impedance?
6. What is meant by unity gain frequency?
7. Why are h-parameters not used at high frequencies?
8. Write the expressions for gain bandwidth product.
9. Draw general frequency response curve of an amplifier.
10. What is meant by gain-bandwidth product?
11. What is base spreading resistance?
12. Draw the hybrid-pi model for a transistor in the CE Configuration.
Long Type Questions
1. Derive the expression for AV, AI, RI, R0 of two stage RC Coupled amplifier.
2. Draw the Darlington circuit and derive the expressions for the overall current gain and input
impedance.
3. Construct CASCODE amplifier and analyze it.
4. Examine the effect of cascading on bandwidth.
5. Sketch the hybrid-PI model of a CE configuration and describe each component in the PI
model
6. Solve the expression for fα, fβ and unity gain bandwidth of CE Amplifier or Short circuit
current gain of CE Amplifier.
7. a. Prove that hfe = gm.rb’e.
b. A Multistage amplifier is to be constructed using 4 identical stages, each of which has lower
cut off frequency 15 Hz and upper cut-off frequency is 30 KHz.
i) What will be lower and upper cutoff frequency of multistage amplifiers?
ii) If the mid band voltage gain of each is 8.2, what will be approximate voltage gain of the 4-
stage amplifier at 75 Hz and at 300 Khz.
UNIT-4 BT LEVEL: III
Short Type Questions
1. Explain different classification of feedback amplifiers?
2. Explain the principle of negative feedback in amplifier?
3. What is the effect of negative feedback on distortion?
4. What is the effect of negative feedback on noise?
5. List the general characteristics of negative feedback amplifiers?
6. Define desensitization factor.
7. Write the closed loop Gain equation.
8. Write the open loop Gain equation.
Long Type Questions
1. Simplify quantitatively about the effect of negative feedback on
i ) Gain ii) Distortion.
2. Calculate input & output impedances of a voltage series feedback amplifier using of negative
feedback.
3. Calculate input & output impedances of a current series feedback amplifier using of negative
feedback.
4. Calculate input & output impedances of a current shunt feedback amplifier using of negative
feedback.
5. Calculate input & output impedances of a voltage shunt feedback amplifier using of negative
feedback.
6. Simplify quantitatively about the effect of negative feedback on Bandwidth.
7. A voltage series negative feedback amplifier has a voltage gain without feedback of
A=500,input resistance Ri=3kohms,output resistance R0=20kohms and feedback ratio is
0.01.Calculate the voltage gain, input resistance, output resistance of the amplifier with
feedback.
UNIT-5 BT LEVEL: V
1. Compare Oscillator and Amplifiers?
2. State Barkhausen criterion for the oscillator?
3. State the advantages of RC phase shift oscillator?
4. In a Hartley oscillator L2= 0.04 mH and C=0.004 µF. if the frequency of Oscillations is 150
KHz, calculate L1 neglect mutual inductance.
5. List the advantages of a crystal oscillator over an LC oscillator?
6. Explain Barkhausen criterion for the oscillator?
7. What is the mechanism involved for oscillations in oscillator.
8. State the advantages of LC Oscillator?
9. What are types of LC Oscillator?
10. Define Oscillator.
Long Type Questions
1. Analyze the operation of Colpitt’s oscillator and calculate its frequency of oscillations.
2. Analyze the operation of Hartley oscillator and calculate its frequency of oscillations
3. Analyze the operation of RC Phase shift oscillator and calculate its frequency of oscillations
4. Analyze operation of Wein Bridge oscillator and calculate its frequency of oscillations
5. Derive the expression for General form of an LC Oscillators.
6. Analyze Crystal Oscillator and find its resonant frequencies.
7. Explain the factors effecting the stability of oscillators.
