28/10/2024
PURe® Casement
Window System
Technical Datasheet
Scope
The PURe® Casement window has been designed to meet
current and future building regulations, with impressive
thermal performance. PURe® is an evolved generation of
aluminium window systems manufactured in the UK. It
combines the long life and low maintenance of powder
coated aluminium with a patented high insulation PUR foam
thermal barrier. PURe® Casement windows are capable of
accepting glazing up to 50mm thick. *Image for indicative
purposes only
Materials Testing
Typical Sizes Width (mm) Height (mm)
• Extruded aluminium is generally Aluminium Alloy 6060.T6/ Top Hung 1500/ 2000 2000*
T66, 6063.T6/T66, 6082.T6 to BS EN 755-9 and EN
Side Hung 1000 1500
12020-2.
**Average U-Values
• Polyamide thermal barriers are manufactured in
accordance with PA66 GF25. Residential CEN standard (Double Glazed) 1.2 W/m²K
Residential CEN standard (Triple Glazed) 0.76 W/m²K
• The Gasketry is generally manufactured in accordance with
BS ISO 3302-1. Commercial CEN standard (Double Glazed) 1.1 W/m²K
Commercial CEN standard (Triple Glazed) 0.73 W/m²K
• The fixings are generally A2 Stainless Steel screws.
Glazing
Thickness 28mm - 50mm (48mm for radius)
Finishes
Testing
PURe® Casement window sections are available typically in
two finishes. Security PAS24 & SBD
• Polyester Powder Coating to BS EN 12206-1 Part 1 Air Permeability 600Pa
painted in house. Surface finish to a minimum of 40 BS6375 -1 Water Tightness 600Pa
microns standard, or enhanced to suit project
requirements, in accordance with ISO 9001, ISO 14001 Wind Resistance 2400Pa
and ISO 45001.
BS6375 - 2 ✓
• Anodised finishes are to BS3897 to a minimum of 25 Acoustics
microns (AA25), supplied in either satin or polished
finish in a limited range of colours. Acoustics performance (IGU Dependent) 42dB reduction is achievable
*See manual for table layouts
**All calculations are based on CEN sized windows at 1230mm x 1480mm ±25%.
Test certifications available upon request.
Construction
PURe® is constructed using mitred corners, joined with
crimped cleats; alignment chevrons assist in clean, accurate
mitres. Integral transoms and mullions are scribed around the
outer frames and fixed with either screwports or shearblocks.
A proprietary sealant is used on all metal joints in line with
good practice. Opening window frames are designed to be
inserted directly into the outer frames using friction stays.
Environmental
Senior Architectural Systems is fully compliant with BS EN ISO
9001, BS EN ISO 14001, ISO 45001 and BES6001 standards.
When used on projects involved in a BREEAM assessment, or
within the Code for a Sustainable Built Environment, (which
therefore involves the Green Guide specification) can offer
significant benefits. For project specific assistance, please
contact our specification team.
A ++
Senior Architectural Systems Ltd, Eland Road, Denaby Main, Doncaster, South Yorkshire, DN12 4HA.
Tel: 01709 772 600 E-mail: [email protected] www.seniorarchitectural.co.uk
Due to a policy of continual product development, Senior Architectural Systems reserves the right to alter any of the specifications given in
this publication without prior notice. The specification for any given application must be checked with Senior Architectural Systems prior to
manufacture. No responsibility for accuracy is accepted by Senior Architectural Systems. Always refer to the Technical Manual.
