MATERIAL SAFETY DATA SHEET
PRODUCT: NATIONAL POLYOLESTER LUBRICANT PE32 HMIS CODES: H F R P
PRODUCT CODE: PE32 1 1 0 -
CHEMICAL NAME/FAMILY: SYNTHETIC ESTER LUBRICATING FLUID
MANUFACTURER: NATIONAL REFRIGERANTS, INC.
ADDRESS: 11401 Roosevelt Boulevard Phila., Pa. 19154
INFORMATION: 800-262-0012 EMERGENCY: 800-424-9300
DATE: 10/09 PREPARER: Ray Madariaga
HAZARDOUS COMPONENTS
MATERIAL CAS NO . APPROXIMATE % TLV
Pentaerythritol ester of heptanoic 68441-94-1 5mg3 (as a mist)
and isopentanoic acids
Mixed pentaerythritol esters of 118685-29-3 5mg3
isononionic and heptanoic acids
Antiwear/antioxidant additive N/A N/A
SARA TITLE III INFORMATION ( 40CFR300 )
EXTREMELY HAZARDOUS SUBSTANCES (40CFR355)
MATERIAL TPQ (LBS) RQ (LBS)
None listed N/A N/A
CERCLA HAZARDOUS SUBSTANCES (40CFR302.4)
MATERIAL WT% RQ (LBS)
None listed N/A N/A
PRODUCT HAZARD CATAGORIES (SARA TITLE III/SECTIONS 311 & 312)
IMMEDIATE NO DELAYED NO
FIRE NO PRESSURE NO
REACTIVE NO CHRONIC NO
TOXIC SUBSTANCES (SARA TITLE III/SECTION 313 & 40CFR372)
MATERIAL CAS NO . WT %
None listed
PAGE 1 P E3 2
PHYSICAL DATA
BOILING POINT VOLATILITY
N/A N/A
SPECIFIC GRAVITY VAPOR PRESSURE
<1.0 g/cc at 77°F (25oC) N/A
VAPOR DENSITY SOLUBILITY IN WATER
N/A at 77oF (25°C) (AIR = 1) Negligible at 77°F (25°C)
pH INFORMATION POUR, CONGEALING OR MELTING POINT
Neutral N/A
F O RM FREEZING POINT
Liquid N/A
COLOR O DO R
Amber Slight chemical odor
HAZARDOUS REACTIVITY
STABILITY
Material is stable. Avoid open flames and high temperatures.
DECOMPOSITION
This material may decompose if exposed to high temperatures (open flames) producing CO and CO2.
INCOMPATABILITY
N/A
POLYMERIZATION
Will not occur.
FIRE AND EXPLOSION INFORMATION
FLASH POINT FLAMMABLE LIMITS IN AIR
>500°F by COC test method LOWER: Not evaluated
UPPER: Not evaluated
AUTOIGNITION TEMPERATURE AUTODECOMPOSITION TEMPERATURE
Not determined Not determined
FIRE AND EXPLOSITION HAZARDS
N/A
PAGE 2 P E3 2
EXTINGUISHING MEDIA
Foam, CO2, Dry Chemical
SPECIAL FIREFIGHTING INSTRUCTIONS
Use water spray to cool surface of container. Use Self Contained Breathing Apparatus (SCBA), avoid breathing
fumes, vapors, or mists. Water may cause frothing.
HEALTH HAZARD INFORMATION
PRINCIPLE HEATLH HAZARDS
SKIN CONTACT: In case of skin contact, remove contaminated clothing and wash skin thoroughly with soap
and water.
EYE CONTACT: If splashed into eyes, flush with clear water for 15-minutes or until irritation subsides. If
irritation persists, call a physician.
INHALATION: Vapor inhalation under ambient conditions is normally not a problem. If overcome by vapor
from hot product, immediately remove from exposure and call a physician. If breathing is irregular or has
stopped, start resuscitation; administer oxygen if available. If overexposure is due to oil mist, remove from
further exposure until excessive oil mist condition subsides.
INGESTION: If ingested, do not induce vomiting. Call a physician immediately.
EXPOSURE LIMIT FOR TOTAL PRODUCT
5mg/m3 for oil mist in air
CARCINOGENICITY
Not listed as a carcinogen by IARC, NTP, OSHA or ACGIH.
SAFETY PRECAUTIONS
Avoid breathing vapors and prolonged skin exposure. Use with sufficient ventilation to keep exposure below
recommended limits.
SIGNS AND SYMPTOMS OF EXPOSURE
None known
PROTECTION INFORMATION
GENERAL CONTROL MEASURES
Normal ventilation for standard manufacturing procedures is generally adequate. Local exhaust should be used
when large amounts are released. Mechanical ventilation should be used in low places. Keep containers closed
when not in use. Do not handle near heat, sparks, flame, or strong oxidants.
PERSONAL PROTECTIVE EQUIPMENT
Butyl gloves should be worn to avoid prolonged or repeated exposure. Chemical splash goggles should be worn
as needed to prevent eye contact. Under normal use, no respiratory protection is required when using this
chemical.
PAGE 3 P E3 2
PERSONAL HYGIENE
Minimize breathing vapor, mist, or fumes. Avoid prolonged contact with skin. Remove contaminated clothing,
and launder or dry-clean before reuse. Cleanse skin thoroughly after contact, especially before eating, with
waterless hand cleaner followed by soap and water.
DISPOSAL INFORMATION
SPILL, LEAK OR RELEASE
Ventilate area. Do not flush into sewers. Dike spill. Collect on absorbent material and transfer to steel drums for
recovery or disposal. Comply with Federal, State and local regulations on reporting releases.
WASTE DISPOSAL
Comply with Federal, State and local regulations.
SHIPPING INFORMATION
*** This product is not regulated by DOT, IMO, ICAO
DOMESTIC--OTHER THAN AIR (DOT)
PROPER SHIPPING NAME:
UN NUMBER: Not applicable
HAZARD CLASS: Not applicable
DOT LABELS: Not applicable
DOT PLACARD: Not applicable
INTERNATIONAL WATER OR AIR (IMO/ICAO)
PROPER SHIPPING NAME:
UN NUMBER: Not applicable
HAZARD CLASS: Not applicable
IMO/ICAO LABEL: Not applicable
__ ______________ ______________ _____________ _______
DISCLAIMER
INFORMATION AND RECOMMENDATIONS CONTAINED HEREIN ARE BELIEVED TO BE ACCURATE AT THE
TIME OF PREPARATION. NO WARRANTY IS MADE CONCERNING THE ACCURACY AND NO LIABILITY SHALL
BE MADE FOR CLAIMS FOR USE OR RELIANCE OF THE RECOMMENDATIONS CONTAINED HEREIN.
PAGE 4 P E3 2
