5.

3
开机 3-5 长按开机键1秒 200mA

长按-键 X7 X7 长按开机键
长按+键
磁吸充电口
单击开机键 双击开机键（模式键）开机键自由
充电状态指示灯闪呼吸灯，充满电常亮蓝灯 切换蓝牙和内存模式 音乐格式支持：MP3，WMA，WAV，APE，FLAC
麦克风 单击开机键

注意：磁吸充电有正负极对应，相互吸附可正常充电，相 强调：开机自动默认蓝牙模式 防水级别：IPX8 （内存版）

音量+ /下一曲
互排斥则无法充电甚至造成短路。
状态。
开机键/模式键 将原装充电数据线连接电脑和耳机，即可读
音量 - /上一曲 取U盘，将电脑歌曲复制到U盘
耳机不能长时间泡海水/盐水，使用后应用淡水冲洗擦干
单击开机键接听 充电磁吸部分容易腐蚀。
单击开机键挂断
如果长时间不使用，请至少一个月充满一次电。
磁吸充电口
请不要私自拆装产品上任何部件，如发现产品有缺陷立
长按开机键2秒 即停止产品使用，联系销售方售后处理。
红灯呼吸
每次运动后请将耳机表面的水擦拭干净，特别是充电磁
常亮蓝灯 吸位置，要及时处理干净，防止汗水，盐水腐蚀充电
口，影响产品寿命。
长按开关键3-5秒 长按2秒开机键 蓝灯5秒慢闪 产品远离火源、热源、冷冻源、化学品，严禁暴力撞击
拆装挤压产品。
长按开关键3-5秒
请使用输出5V1A及以内的充电头。

Charge Music Play Operating instruction AI intelligent voice control

(Phone needs to support
voice wake-up function) Product parameter
The headphone with a rechargeable battery , the first ity
Bone Conduction Earphone How to pair with Bluetooth nform
Bone Conduction Bluetooth Earphone use of the headset must be fully charged to the battery . Function Earphone status Press and hold “ ” Function Earphone status Operation Charging time: About 2 hours Version: 5.3 te of co
In use , if the voice “ Di-Di ” prompting low power , Bluetooth pairing: In the off state, press and hold the Ce rtifica
Increase volume Play music click “- ” Bluetooth is Press and hold the “ ” Distance: Bluetooth 10 meter Input: 5V/500mA
that the battery is low , then you need to charge the The power button for 3 to 5 seconds, the indicator light Voice control
Reduce volume Play music click “+” connected (around 1 second) Battery: 200mAh
headset . will enter the red and blue light flashing state, and then
Next song Play music Press and Hold “ + ” enter the pairing state. Turn on the Bluetooth Play: More than 6 hours@65% volume
Note: In the Bluetooth connection status, touch the Agreement: A2DP, AVRCP, HSP, HFP
the charging cable should be connected to the Last song Play music Click and Hold “ - ” (mobile phone / computer) on the device and search for
multi-function button on the right for 1 second to wake Music format support: MP3, WMA, WAV, APE, FLAC
headset’s magnetic charging port , about 2 hours to Pause Play music Click and Hold “ ” the device name " X7 ", Click the device"
up. After hearing the prompt, you can voice control the Product warranty card
fill . Charging status indicator flashing breathing light , X7 "to pair and connect. This card is a product warranty certificate, please keep
Resume Pause Click and Hold “ ” phone, saving time to operate the phone, fast and smart
Microphone full charge often blue light . Care and cleaning
it properly
Bluetooth / MP3 mode switching: Double click the
Volume + / previous Answer the phone power button (mode) power button freeSwitch bluetooth The headset can not soak seawater / salt water for a long
Note : Magnetic charging has a positive and negative Product name: Product model:
and memory mode. time , filling the magnetic suction part is easy to corrode .
Power on / mode key pole corresponds to each other adsorption can be Function Earphone status Press and hold “ ”
Note: Bluetooth mode is default for boot Purchase date: Client's name:
charged normally , mustual repulsion can not be If not used for a long time , please at least once a
Volume - / next
charged or even cause a short circuit . month full of electricity . Contact:
charge port Answer the call Phone calls in Click “ ” to answer
Please do not disassemble any parts of the product, if
indicator light Warning : The rechargeable battery of this product must Click “ ” to hang up you find that the product has defects , that is ,stop using
be properly disposed of for recycling . please do not put Indicator the product , contact the sales side after sales service.
the battery into the fire ,so as not to cause an explosion . Product maintenance records
Operating instruction Please wipe the water on the surface of the headset after
Being charging Red light (flash) each movement , especially the charging port , to deal Date Bad phenomenon Solution
Decline the call Phone calls in Double click “ ”
with clean in time to prevent port ,affecting the life of the
Function Operation Indicator Charging completed Blue light (remain on)
charging port ,affecting the life of the product.
Press and hole “ ” volume control calling click "+" / "-" Keep the product away from fire ,heat,freezing sources,
On Light is on Flash in red and blue
Instructions for usage and warranty (around 1-3 seconds ) Waiting for connection chemicals, violent impact disassembly and extrusion products
Phone / Blueto alternately
Press and hole “ ” calling Click and hold “ ” are strictly prohibited .
Off Light is off oth earphone
(around 1-3 seconds ) (arond 2 second) Bluetooth connected Light is off Please use a charging head with an output of 5V1A or less .
switch
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement in portable exposure condition without restriction.