OPERATING MANUAL
P O W E R
AMPLIFIER
PA-920/935
1
UNPACKING AND INSTALLATION
Although it is neither complicated to install nor difficult to operate your amplifier, a few minutes of your time is
required to read this manual for properly wired installation and becoming familiar with its many features and how
to use them. Please take a great care in unpacking your set and do not discard the carton and other packing
materials. They may be needed when moving your set and are required if it ever becomes necessary to return
your set for services. Never place the unit near radiator, in front of heating vents, to direct sun light, inexcessive
humid or dusty location to avoid early damage and for your years of quality use. Connect your complementary
components as illustrated in the following page.
This symbol is intended to alert the user to the
presence of uninsulated “dangerous voltage” within
CAUTION the product’s enclosure that may be of sufficient
RISK OF ELECTRIC SHOCK magnitude to constitute a risk of electric shock to
DO NOT OPEN
persons.
This symbol is intended to alert the user to the
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK. presence of important operation and maintenance
(servicing) instructions in the literature accompanying
DO NOT REMOVE COVER (OR BACK).
the appliance.
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Caution: To prevent electric shock do not use this (polarized) plug with
an extension cord, receptacle or other outlet unless the blades
can be fully inserted to prevent blade exposure.
WARNING Attentions: Pour prévenir les chocs électriques ne pas utiliser cette fiche
polarisée avec un prolongateur, une prise de courant on une
autre sortie de courant, sauf si les lames peuvent étre
To prevent fire or shock hazard, do not
insérées à fond sans en laisser aucune partie à découvert.
expose the unit to rain or moisture.
2
FEATURES
• VERSATILE AND CONVENIENT
3 channels of input signals from MIC1, MIC2/AUX1 and MIC3/AUX2 are provided, and Bass and Treble are
incorporated for versatile and convenient use. MIC, AUX input have PL55 phone jack and Telephone IN input
have screw terminal.
3
FRONT PANEL CONTROLS
5 4 3 2 1
PA-935 AMPLIFIER
MASTER VOLUME
10 POWER ON
8 12
6 14
MIC 1 MIC 2/AUX 1 MIC 3/AUX2
5 5 5 BASS TREBLE
4 6 4 6 4 6 0 0 POWER
3 7 3 7 3 7
4 16 ON OFF
2 8 2 8 2 8
2 18
1 9 1 9 1 9
0 0 0 -10 +10 -10 +10
10 10 10 0 20
6 7
1. POWER SWITCH
Pressing this switch to ON will make the power indication LED ON and supply the power to this unit.
2. POWER LED
Pressing power switch to ON will make the power indication LED ON.
3. TREBLE
This control is used for modifying the high frequency sound.
4. BASS
This control is used for modifying the low frequency sound.
5. MIC VOLUME
You can adjust the volume level of Mic 1, Mic 2, and Mic 3.
6. AUX VOLUME
You can adjust the volume level of Aux 1 and Aux 2.
7. MASTER VOLUME
This control is used for adjusting the volume of finally mixed sound.
4
REAR PANEL CONTROLS
1 2 3 4 5
OUTPUT GND INPUT
FUSE
T1AL/250V MIC3 MIC2 MIC1
S/N
COM 4 B 70V 100V BALANCED
INPUT
~AC INPUT T/P AUX 2 MIC 3 AUX 1 MIC 2
230V 50Hz,72W
GND TEL/MUTE MIC1/MUTE
AUX 1 AUX 2
STEREO MIXED BALANCED
MODEL:PA-935 AMPLIFIER
10 9 8 7 6
1. AC CORD
Plug this AC input cord into AC outlet.
2. FUSE HOLDER (AC)
This fuse holder contain AC fuse, replace only with same type fuse when it is blown out. If it continuously
blow, stop replacing fuse and refer servicing to qualified personnel.
Voltage AC 220V/240V
PA-920 Fuse Rating 0.5A/250V
PA-935 Fuse Rating 1A/250V
3. SPEAKER OUTPUT TERMINAL
This terminal is for speaker wire connection. You can select one of 4 ohms, 8 ohms, 70 volts and 100 volts.
Be sure not to make the total impedance less than rated impedance.
4. GND TERMINAL
This is ground terminal to be connected with chassis of the turntable etc, to reduce hum to minimum. To
further minimize hum, it may be necessary to connect this terminal with a wire to the nearest water pipe
which goes directly to real ground.
5. MIC 1, 2, 3 INPUT (PHONE JACK)
These phone jacks are for the Mic 1 and Mic 2 input. Input sensitivity and impedance in PHONE JACK
2mV/600Ω.
5
6. MUTE CONTROL
When the other signal is muted by Mic 1 and Telephone paging, this control is used for adjusting the muting
level.
7. MIC 2/AUX 1 SELECTOR SWITCH
This switch is used to select MIC 2 or AUX 1.
8. MIC 3/AUX 2 SELECTOR SWITCH
This switch is used to select MIC 3 or AUX 2.
9. TELEPHONE IN TERMINAL
These terminals are to be connected to telephone exchange system for paging.
NOTE: When there are paging signal through this terminals, the other input signals are muted.
10. AUX INPUT (PHONE JACK)
You can connect the sound source of tuner, deck, CD, video, etc to this input.
6
INSTALLATION OF THE SPEAKERS
When you connect the speaker, remove the power cord from AC outlet. And use the suitable terminals
connecting way as belows. Be sure that total impedance is not less than rated impedance.
• AC VOLTAGE: 220V–240V ONLY
PA-920 8.9V 12.65V 70V 100V
VOLTAGE
PA-935 11.8V 16.73V 70V 100V
PA-920 4 OHMS 8 OHMS 245 OHMS 500 OHMS
IMPEDANCE
PA-935 4 OHMS 8 OHMS 140 OHMS 285 OHMS
FOR 4Ω TERMINAL FOR 8Ω TERMINAL
12V 16.7V 140Ω 285Ω (PA-935) 12V 16.7V 140Ω 285Ω (PA-935)
9V 12.8V 245Ω 500Ω (PA-920) 9V 12.8V 245Ω 500Ω (PA-920)
(Figure 2-1) (Figure 2-2)
FOR 70V TERMINAL FOR 100V TERMINAL
12V 16.7V 140Ω 285Ω (PA-935) 12V 16.7V 140Ω 285Ω (PA-935)
9V 12.8V 245Ω 500Ω (PA-920) 9V 12.8V 245Ω 500Ω (PA-920)
Be sure that total impedance is not less than Be sure that total impedance is not less than
rated impedance. rated impedance.
(Figure 2-3) (Figure 2-4)
7
CONNECTIONS
SPEAKERS
EARTH
OUTPUT GND INPUT
FUSE
T1AL/250V MIC3 MIC2 MIC1
S/N
COM 4 B 70V 100V BALANCED
INPUT
~AC INPUT T/P AUX 2 MIC 3 AUX 1 MIC 2
230V 50Hz,72W
GND TEL/MUTE MIC1/MUTE
AUX 1 AUX 2
STEREO MIXED BALANCED
MODEL:PA-935 AMPLIFIER
TUNER
TELEPHONE
EXCHANGE SYSTEM
CASSETTE DECK
8
SCHEMATIC DIAGRAM (PA-920)
9
SCHEMATIC DIAGRAM (PA-935)
10
SPECIFICATIONS
PA-920
ELECTRICAL
• Rated Output Power (at THD: 10%)................................................................................................20W (RMS)
4Ω/8.9V, 8Ω/12.8V, 245Ω/70V, 500Ω/100V
• Frequency Response...............................................................................................................150Hz to 15KHz
• Total Harmonic Distortion..........................................................................................................Less than 0.5%
• Tone Control Effect...................................................................................................................................±10dB
• Signal to Noise Ratio ..............................................................................................................Better than 60dB
• Input Sensitivity/Impedance..............................................................................................Mic Input 2mV/600Ω
Aux Input 150mV/1KΩ
Telephone Input 0.775V/600Ω
GENERAL
• Power Source ............................................................................................................................AC 220V–240V
• Weight ......................................................................................................................................................3.5 Kg
• Dimensions ..........................................................................................................290(W) 76(H) 196(D) mm
PA-935
ELECTRICAL
• Rated Output Power (at THD: 5%)..................................................................................................35W (RMS)
4Ω/11.8V, 8Ω/16.7V, 140Ω/70V, 285Ω/100V
• Frequency Response...............................................................................................................150Hz to 15KHz
• Total Harmonic Distortion..........................................................................................................Less than 0.5%
• Tone Control Effect...................................................................................................................................±10dB
• Signal to Noise Ratio ..............................................................................................................Better than 60dB
• Input Sensitivity/Impedance..............................................................................................Mic Input 2mV/600Ω
Aux Input 150mV/1KΩ
Telephone Input 0.775V/600Ω
GENERAL
• Power Source ............................................................................................................................AC 220V–240V
• Weight ......................................................................................................................................................4.4 Kg
• Dimensions ..........................................................................................................290(W) 76(H) 196(D) mm
*Specifications and design subject to change without notice for improvements.
MADE IN KOREA
NO: 9007931102A
