TITANIUM Ti70/Ti100/Ti150
INSTALLATION AND OPERATION
MANUAL Version: July 2020
1
1
2
•
•
•
•
•
•
•
•
3
•
•
•
•
•
•
•
•
•
4
•
•
•
•
•
•
•
•
5
6
b
7
8
•
9
10
Sm oke Sensor Notes
Alarm Inputs in Connect to Smoke Screen ground through
Alarm Green clean contacts changing state on "Alarm".
Pow er from Smoke 0v Outputs in These are clean contacts changing state
Screen 12v Grey w hen the marked function changes status .
Pow er out in
Sm oke Screen Blue Total output must not be greater than 1000mA.
Alarm Panel or sim ilar control device 12v
DC output for additional devices.
Gnd
Set Z1 (Set) "Set" from Alarm Panel
Intruder Z2 (Trigger) "Alert" from Alarm Panel
Z3 (Top-up) Smoke top up facility - see manual for options.
Alarm Panel ouput contacts should be clean Outputs Gnd Ground
relay closed pairs energising open. Smoke Z4 (Hold-off) "Hold-off" input from PIR or similar device.
Screen inputs can be individually Panic input Z5 - Panic input "Panic" input.
programmed to respond to various input Gnd Ground
types (EOL, DEOL etc) in the menu settings. Z6 (Isolate) Ground this pin to prevent the Smoke Screen from activating.
Isolate
External tamper input Detects a n/c circuit going open.
RS485 A
RS485 communication connections.
connection B
Input 1 Zone Ready
Smoke Screen Ready indication.
Ready Status Ground Ready
Input 2 Zone Tamper
Internal Tamper indication.
Machine tamper Ground Tamper
Input 3 Zone Battery Fail
Battery pow er failure.
Alarm Panel detects n/c circuit going open to Battery failure Ground Battery Fail
signal the specified event. These Smoke Input 4 Zone Mains Fail
Mains pow er failure.
Screen outputs are normally closed going Mains failure Ground Mains Fail
open w hen active. Input 5 Zone Fluid Low
Fluid reservoir contents low .
Fluid low Ground Fluid Low
Input 6 Zone Fluid Empty
Fluid reservoir empty.
Fluid empty Ground Fluid Empty
Input 7 Zone Smoke Verification
Smoke Screen making smoke indication.
Making smoke Ground Smoke Verification
Input 8 Zone PGM 1
Programmable output 1 Ground PGM 1
Alarm Panel detects n/c or n/o circuit (as set
Input 9 Zone PGM 2
in the Smoke Screen Configuration settings) 3 x programmable outputs - see manual for options.
Programmable output 1 Ground PGM 2
changing state to signal the specified event.
Input 10 Zone PGM 3
Programmable output 1 Ground PGM 3
PIR or similar hold-off device
Pow er from Smoke 12v
Screen 0v
Tamper
Tamper
Alarm
Alarm
11
12
13
•
•
14
15
16
17
18
19
20
21
22
23
24
•
•
•
•
25
•
•
•
26
27
28
•
•
•
•
•
•
•
•
•
•
•
•
•
29
30
Concept Smoke Screen Limited
Unit 1C North End Business Park, Station Road, Swineshead,
Lincolnshire, PE20 3PW, United Kingdom
Tel: +44 (0) 1205 821111 Fax : +44 (0) 1205 820316
Ti70/Ti100/Ti150
(Titanium Version July 2020)
