MATERIAL SAFETY DATA SHEET
A87W1151 DATE OF PREPARATION
15 00 Oct 17, 2015
SECTION 1 — PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NUMBER
A87W1151
PRODUCT NAME
SUPERPAINT® Interior Satin Latex Wall Paint, Extra White
MANUFACTURER'S NAME
THE SHERWIN-WILLIAMS COMPANY
101 Prospect Avenue N.W.
Cleveland, OH 44115
Telephone Numbers and Websites
Product Information www.sherwin-williams.com
Regulatory Information (216) 566-2902
www.paintdocs.com
Medical Emergency (216) 566-2917
Transportation Emergency* (800) 424-9300
*for Chemical Emergency ONLY (spill, leak, fire, exposure, or
accident)
SECTION 2 — COMPOSITION/INFORMATION ON INGREDIENTS
% by Weight CAS Number Ingredient Units Vapor Pressure
1.0 14464-46-1 Cristobalite
ACGIH TLV 0.025 mg/m3 as Resp. Dust
OSHA PEL 0.05 mg/m3 as Resp. Dust
4 1317-65-3 Calcium Carbonate
ACGIH TLV 10 mg/m3 as Dust
OSHA PEL 10 mg/m3 Total Dust
OSHA PEL 5 mg/m3 Respirable Fraction
20 13463-67-7 Titanium Dioxide
ACGIH TLV 10 mg/m3 as Dust
OSHA PEL 10 mg/m3 Total Dust
OSHA PEL 5 mg/m3 Respirable Fraction
SECTION 3 — HAZARDS IDENTIFICATION
ROUTES OF EXPOSURE HMIS Codes
INHALATION of vapor or spray mist. Health 1*
EYE or SKIN contact with the product, vapor or spray mist. Flammability 0
EFFECTS OF OVEREXPOSURE Reactivity 0
EYES: Irritation.
SKIN: Prolonged or repeated exposure may cause irritation.
INHALATION: Irritation of the upper respiratory system.
In a confined area vapors in high concentration may cause headache, nausea or dizziness.
SIGNS AND SYMPTOMS OF OVEREXPOSURE
Redness and itching or burning sensation may indicate eye or excessive skin exposure.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
None generally recognized.
CANCER INFORMATION
For complete discussion of toxicology data refer to Section 11.
page 1 of 4
A87W1151
SECTION 4 — FIRST AID MEASURES
EYES: Flush eyes with large amounts of water for 15 minutes. Get medical attention.
SKIN: Wash affected area thoroughly with soap and water.
Remove contaminated clothing and launder before re-use.
INHALATION: If affected, remove from exposure. Restore breathing. Keep warm and quiet.
INGESTION: Do not induce vomiting. Get medical attention immediately.
SECTION 5 — FIRE FIGHTING MEASURES
FLASH POINT LEL UEL FLAMMABILITY CLASSIFICATION
Not Applicable Not Not Not Applicable
Applicable Applicable
EXTINGUISHING MEDIA
Carbon Dioxide, Dry Chemical, Alcohol Foam
UNUSUAL FIRE AND EXPLOSION HAZARDS
Closed containers may explode (due to the build-up of pressure) when exposed to extreme heat.
During emergency conditions overexposure to decomposition products may cause a health hazard. Symptoms may not be immediately
apparent. Obtain medical attention.
SPECIAL FIRE FIGHTING PROCEDURES
Full protective equipment including self-contained breathing apparatus should be used.
Water spray may be ineffective. If water is used, fog nozzles are preferable. Water may be used to cool closed containers to prevent pressure
build-up and possible autoignition or explosion when exposed to extreme heat.
SECTION 6 — ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED
Remove all sources of ignition. Ventilate the area.
Remove with inert absorbent.
SECTION 7 — HANDLING AND STORAGE
STORAGE CATEGORY
Not Applicable
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
Keep container closed when not in use. Transfer only to approved containers with complete and appropriate labeling. Do not take internally.
Keep out of the reach of children.
SECTION 8 — EXPOSURE CONTROLS/PERSONAL PROTECTION
PRECAUTIONS TO BE TAKEN IN USE
Use only with adequate ventilation.
Avoid contact with skin and eyes. Avoid breathing vapor and spray mist.
Wash hands after using.
This coating may contain materials classified as nuisance particulates (listed "as Dust" in Section 2) which may be present at hazardous
levels only during sanding or abrading of the dried film. If no specific dusts are listed in Section 2, the applicable limits for nuisance dusts
are ACGIH TLV 10 mg/m3 (total dust), 3 mg/m3 (respirable fraction), OSHA PEL 15 mg/m3 (total dust), 5 mg/m3 (respirable fraction).
Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may
cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other
hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper
containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your
local health authority.
VENTILATION
Local exhaust preferable. General exhaust acceptable if the exposure to materials in Section 2 is maintained below applicable exposure
limits. Refer to OSHA Standards 1910.94, 1910.107, 1910.108.
RESPIRATORY PROTECTION
If personal exposure cannot be controlled below applicable limits by ventilation, wear a properly fitted organic vapor/particulate respirator
approved by NIOSH/MSHA for protection against materials in Section 2.
When sanding or abrading the dried film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may be generated from this
product, underlying paint, or the abrasive.
PROTECTIVE GLOVES
Wear gloves which are recommended by glove supplier for protection against materials in Section 2.
EYE PROTECTION
Wear safety spectacles with unperforated sideshields.
page 2 of 4
A87W1151
SECTION 9 — PHYSICAL AND CHEMICAL PROPERTIES
10.86 lb/gal
PRODUCT WEIGHT 1301 g/l
1.31
SPECIFIC GRAVITY
212 - 213 °F
BOILING POINT 100 - 100 °C
Not Available
MELTING POINT
62%
VOLATILE VOLUME
Slower than
EVAPORATION RATE
ether
VAPOR DENSITY Heavier than air
SOLUBILITY IN WATER Not Available
pH > 2.0, < 11.5
VOLATILE ORGANIC COMPOUNDS (VOC Theoretical - As Packaged)
0.32 lb/gal 39 g/l Less Water and Federally Exempt Solvents
0.13 lb/gal 15 g/l Emitted VOC
SECTION 10 — STABILITY AND REACTIVITY
STABILITY — Stable
CONDITIONS TO AVOID
None known.
INCOMPATIBILITY
None known.
HAZARDOUS DECOMPOSITION PRODUCTS
By fire: Carbon Dioxide, Carbon Monoxide
HAZARDOUS POLYMERIZATION
Will not occur
SECTION 11 — TOXICOLOGICAL INFORMATION
CHRONIC HEALTH HAZARDS
Crystalline Silica (Quartz, Cristobalite) is listed by IARC and NTP. Long term exposure to high levels of silica dust, which can occur only when
sanding or abrading the dry film, may cause lung damage (silicosis) and possibly cancer.
IARC's Monograph No. 93 reports there is sufficient evidence of carcinogenicity in experimental rats exposed to titanium dioxide but
inadequate evidence for carcinogenicity in humans and has assigned a Group 2B rating. In addition, the IARC summary concludes, "No
significant exposure to titanium dioxide is thought to occur during the use of products in which titanium is bound to other materials, such
as paint."
TOXICOLOGY DATA
CAS No. Ingredient Name
14464-46-1 Cristobalite
LC50 RAT 4HR Not Available
LD50 RAT Not Available
1317-65-3 Calcium Carbonate
LC50 RAT 4HR Not Available
LD50 RAT Not Available
13463-67-7 Titanium Dioxide
LC50 RAT 4HR Not Available
LD50 RAT Not Available
SECTION 12 — ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION
No data available.
SECTION 13 — DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD
Waste from this product is not hazardous as defined under the Resource Conservation and Recovery Act (RCRA) 40 CFR 261.
Incinerate in approved facility. Do not incinerate closed container. Dispose of in accordance with Federal, State/Provincial, and Local
regulations regarding pollution.
page 3 of 4
A87W1151
SECTION 14 — TRANSPORT INFORMATION
Multi-modal shipping descriptions are provided for informational purposes and do not consider container sizes. The presence of a shipping
description for a particular mode of transport (ocean, air, etc.), does not indicate that the product is packaged suitably for that mode of
transport. All packaging must be reviewed for suitability prior to shipment, and compliance with the applicable regulations is the sole
responsibility of the person offering the product for transport.
US Ground (DOT)
Not Regulated for Transportation.
Canada (TDG)
Not Regulated for Transportation.
IMO
Not Regulated for Transportation.
IMO
Not Regulated for Transportation.
IATA/ICAO
Not Regulated for Transportation.
SECTION 15 — REGULATORY INFORMATION
SARA 313 (40 CFR 372.65C) SUPPLIER NOTIFICATION
CAS No. CHEMICAL/COMPOUND % by WT % Element
No ingredients in this product are subject to SARA 313 (40 CFR 372.65C) Supplier Notification.
CALIFORNIA PROPOSITION 65
WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
TSCA CERTIFICATION
All chemicals in this product are listed, or are exempt from listing, on the TSCA Inventory.
SECTION 16 — OTHER INFORMATION
This product has been classified in accordance with the hazard criteria of the Canadian Controlled Products Regulations (CPR) and the
MSDS contains all of the information required by the CPR.
The above information pertains to this product as currently formulated, and is based on the information available at this time. Addition of reducers or other
additives to this product may substantially alter the composition and hazards of the product. Since conditions of use are outside our control, we make no
warranties, express or implied, and assume no liability in connection with any use of this information.
page 4 of 4
