Scribd
Upload
13 views1 page

Temperature Settings

The document outlines temperature settings for a system, detailing sources for temperature signals, including custom NTC designs and integrated temperature sensing options. It explains how to manage temperature thresholds for Over Temperature Protection (OTP) and VR-HOT fault activation, including the use of offsets for measurement accuracy. Additionally, it describes the hysteresis behavior for VR-HOT warnings to prevent false triggers.

Uploaded by

Oem Test
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
13 views1 page

Temperature Settings

The document outlines temperature settings for a system, detailing sources for temperature signals, including custom NTC designs and integrated temperature sensing options. It explains how to manage temperature thresholds for Over Temperature Protection (OTP) and VR-HOT fault activation, including the use of offsets for measurement accuracy. Additionally, it describes the hysteresis behavior for VR-HOT warnings to prevent false triggers.

Uploaded by

Oem Test
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Temperature Settings Temperature Source:

Temperature signal comes from :


Custom NTC design :
Shutdown response :
-ATSEN with NTC: Use an external NTC
This button open a new window where
What to do when a temperature threshold is resistor to measure temperature. Typically
calculations can be done when a non
passed. Valid only for the OTP detection. the NTC is placed near output inductors.
standard NTC is used
-ATSEN with Integrated Tsense: Available
if the power stage(s) in Loop A provide an
integrated temperature sense
measurement
-Disable: Do not use the temperature
function
For LoopB it can also be set to follow the
loop A setting.

Temp Offset:
Allow an offset to be entered to
compensate for any measurment errors or
offset due to location of temperature
sensor.
OTP Shutdown:
Select the temperature for when Over
Temperature Shutdown is to be acitvated.

VR_HOT :
Select the temperature for when VR-HOT
fault and pin to be acitvated. This function
have a 3% hysteresis. i.e. When set to
100C the VR_HOT warning will be set
when temperature goes above 100C and
stay on until temperature droppes 3%
(97C) then the fault flag reset itself.
2017-10-17 restricted Copyright © Infineon Technologies AG 2017. All rights reserved.
СКАЧАНО С WWW.SW.BAND - ПРИСОЕДИНЯЙСЯ!Infineon Proprietary 1

You might also like