Bmjvgx wek¦we`¨vjq
cÖkœc‡Î †Kvb DׄwZ _vK‡j †h cy¯ZK n‡Z Zv M„nxZ n‡q‡Q Zvi bvg, MÖš’vKv‡ii
bvg, ms¯‹iY I c„óv msL¨v cÖkœc‡Îi cv`‡`k Aek¨B D‡j¬L Ki‡Z n‡e|
First Year Final cix¶v t 2020
c‡Îi c~Y© wk‡ivbvg t Basic Electrical Engineering cÎ t ICT-1103
c~Y©gvb t 70 mgq t
04 N›Uv
K) Wvb cv‡k¦© D‡j¬wLZ msL¨v c~Y©gvb ÁvcK
L) mKj cÖ‡kœi gvb mgvb
M) cix¶v_©x‡`i cÖwZ †Kvb wb‡`k© _vK‡j
(a) Define the terms electric potential, resistance and current. 3
(b) Write the characteristics of open and short circuit. 3
(c) What is the importance of network theorems? Classify network analysis methods. 3
(d) Define circuit, unilateral circuit, bilateral circuit, loop and mesh. 5
(a) State and explain Kirchhoff’s current and voltage law. 4
(b) Explain Nodal Analysis with voltage source. 4
(c) State Superposition theorem. Explain it by using suitable example. 2+4
(a) State Thevenin’s theorem and explain how to thevenize a given circuit? 5
(b) Using Thevenin’s theorem calculates the current following through the R2 resistor of the 5
following circuit (where the values of resistances are in ohm):
R1 R2
3 4
+ Is1
V1 R4 10A
12V R3
6 2
(c) Explain the maximum power transfer theorem. 4
(a) Define inductor & capacitor. 3
(b) State and explain brifly Ampere’s circuits law. 5
(c) Define electromagnetic induction. Write the laws regarding to the magnitude and direction 6
of induced emf.
K) cÖ‡qvRb bv _vK‡j †K‡U w`‡Z n‡e| cªkœcÎ
KZv©i ¯^v¶i
Bmjvgx wek¦we`¨vjq
(a) An alternating current of frequency 50 Hz has a maximum value of 50 A. Find it’s 5
instantaneous values 1/600 seconds after the instant the current is zero and after the instant the
current is 50A.
(b) Represent the following voltages by appropriate vectors and find the resultant voltage. 4
e1=7sinωt, e2=10cos (ωt+30o), e3=15sin (ωt-45o).
(c) Deduce the equation of current and power when an alternating voltage V msinωt is applied 5
to an inductor.
(a) Deduce the equations of voltage, current and power of a series RL circuit. 5
(b) A voltage e(t) = 100 sin 314t is applied to a series circuit consisting of 10 ohm resistance, 5
0.0318 Henry inductance and a capacitor of 63.6 μF. Calculate: 1) expression for i 2) phase
angle between voltage and current 3) power factor 4) active power consumed 5) peak value
of pulsating energy.
(c) What is resonance curve? Discuss about half-power bandwidth. 4
(a) A total current of 10A flows through the parallel combination of three impedances (2-J5) 5
Ω, (6+J3) Ω and (3+J4) Ω. Calculate the current following through each branch and also find
the power factor of the combination.
(b) A circuit connected to a 115V, 50Hz supply takes 0.8A current at a pf of 0.3lagging. 4
Calculate the resistance and inductance of the circuit if the elements are in parallel.
(c) Discuss about the graphical representation of series resonance. 5
(a) What is a tuning circuit? Write the operating characteristics of a tuning circuit. 3
(b) Define the different types of filter circuits. 4
(c) Describe the charging and discharging of a capacitor. 7
K) cÖ‡qvRb bv _vK‡j †K‡U w`‡Z n‡e| cªkœcÎ
KZv©i ¯^v¶i
(b) Define the terms magnetic field strength, magnetic potential, flux density,
permeability and curie point.
(c) Write about the essentials of an electronic instrument.
(d) Distinguish between electronic and electrical instruments.
(a) Briefly describe about the magnitude and direction of force between two parallel 5
Current carrying conductors.
(b) Define electromagnetic induction. Briefly describe the law regarding the direction 5
of induced current.
(c) Deduce the equation of magnetizing force along the axis of a circular coil and then 5
Determine the force at 100m apart on the axis of a double-turn circular coil of 50m
diameter that carries a direct current of 28X104Amp.
