[Type text]
Mini Project on Theft Alarm using Tinkercad
Objective of the project to create a theft alarm.
What will happen when a thief comes. It will be detected by PIR
sensor and it give signal to LED to glow, buzzer to produce sound, LCD
to display a message (means alert by light, sound, message)
[Type text]
[Type text]
Supplies
Computer and internet connection (In TinkerCad Arduino Uno R3,
Breadboard, 2 resistor(220 ohms), led, potentiometer, buzzer, LCD, PIR
sensor is required)
Step 1: Interfacing of Components
[Type text]
[Type text]
1. LED interface to digital pin no. 7 via 220 ohm resistor
[Type text]
[Type text]
2. buzzer to digital pin no. 8
3. PIR sensor digital pin no. 4
4. LCD interfacing:
5. GND to ground pin
6. VCC to 5V
7. contrast(v0) to potentiometer
8. Register select(RS) to digital pin no.13
9. Read/write(RW) to ground pin
10. Enable to digital pin no.12
11. DB4 to digital pin no. 6
12. DB5 to digital pin no. 5
13. DB6 to digital pin no. 3
14. DB7 to digital pin no. 2
15. LED anode to 5v via 220 ohm resistor
16. LED cathode to ground pin
Step 2: Text Coding
Steps involves are:
[Type text]
[Type text]
1. include Liquid Crystal Library.
2. Create object for LCD
3. Create variables for led, buzzer, PIR sensor, PIRstatus(for HIGH and
LOW)
4. initialize the pinMode in setup function.
5. In loop function we use if else condition
6. If something is there in the range of a PIR sensor (PIRstatus is
HIGH) buzzer will produce a sound, LED will glow and LCD will
display 'ALERT'.
7. else nothing will work and LCD displays 'SAFE'.
Step 3: Simulation
Last step is to check if it is working or not. Click on start simulation to
see its working
Conclusion
Thus the theft alarm is designed and verified successfully using
Tinkercad.
[Type text]
