Scribd
Upload
10 views3 pages

Experiment 4 - Hydraulic - Basic

The document outlines Experiment 4 on the hydraulic vice, which is used for clamping objects and drilling. It details the objectives, including familiarization with pressure sequence circuits and practical assembly of the hydraulic circuit. The experiment involves pressing a workpiece, drilling, and retracting the cylinder after operation.

Uploaded by

S.A. Beskales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
10 views3 pages

Experiment 4 - Hydraulic - Basic

The document outlines Experiment 4 on the hydraulic vice, which is used for clamping objects and drilling. It details the objectives, including familiarization with pressure sequence circuits and practical assembly of the hydraulic circuit. The experiment involves pressing a workpiece, drilling, and retracting the cylinder after operation.

Uploaded by

S.A. Beskales
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Name

ID
Group

Experiment 4: Hydraulic Vice

Introduction:
Hydraulic vice is used for clamping objects by placing them on the table and then
closing the movable jaw till a required pressure is reached.

Figure 1: Example for hydraulic vice

Experiment Objectives:
 To be familiar with a pressure sequence circuit
 Development of hydraulic circuit diagram
 Drawing the displacement-step diagram
 Practical assembly of the circuit
 Systematic commissioning with setting of pressure and flow rate

Experiment Description

Figure 2: Hydraulic vice

1- The hydraulic vice is used to press work pieces together for drilling.

Industrial Automation Department 1 Hydraulic - Basic


2- Cylinder 1A1 presses a workpiece into the housing. This operation should be
carried out slowly at a constant speed.
3- When the pressure in cylinder 1A1 has reached 20 bar (workpiece pressed
into place).
4- A hole is drilled through the workpiece and housing. The drill is driven by a
hydraulic motor.
5- After the drilling operation, the drill is switched OFF and cylinder 1A1 is
retracted

Required Components and Accessories

Quantity Item Symbol

1 Double acting Cylinder

2 Pressure relief valve

1 4/3 way valve

- Hydraulic motor

Hydraulic hoses for


connections

1- Describe the hydraulic circuit operation.

Industrial Automation Department 2 Hydraulic - Basic


2- Complete the Hydraulic circuit diagram for the circuit

Industrial Automation Department 3 Hydraulic - Basic

You might also like