Scribd
Upload
99 views1 page

EntraFlo Quick Start Guide

The document provides operating instructions for the ENT199235 pump, detailing steps for setup, infusion rate adjustment, and dose limit settings. It includes guidance on preparing the feeding set, monitoring accumulated volume, and clearing it if necessary. The instructions emphasize the pump's memory feature and how to manage its operation effectively.

Uploaded by

Christoph Nerz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
99 views1 page

EntraFlo Quick Start Guide

The document provides operating instructions for the ENT199235 pump, detailing steps for setup, infusion rate adjustment, and dose limit settings. It includes guidance on preparing the feeding set, monitoring accumulated volume, and clearing it if necessary. The instructions emphasize the pump's memory feature and how to manage its operation effectively.

Uploaded by

Christoph Nerz
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Operating Instructions for ENT199235

1. Plug the power cord into a 120 VAC.,


60 HZ. three wire grounded outlet.
2. Press ON; alarm will sound briefly. Remember,
the pump has memory and will automatically recall INFUSION RATE VOLUME DELIVERED / DOSE LIMIT

the previous parameter settings. (Diagram 1) mL/hr mL

SET

3. Check Flow/Infusion Rate. If change is desired,


DOSE
LIMIT

press or to change rate setting. (Diagram 1)


RESET

RUN

4. Check Dose Limit by pressing SET DOSE LIMIT.


ON OFF PAUSE
BATTERY
CHARGING

LOW BATTERY OCCLUSION/ DOSE

If change is desired, press or within 3 seconds


BATTERY IN USE EMPTY COMPLETE

to change limit setting (Diagram 1). Zero Dose Limit


implies no dose limit monitoring by pump.
DIAGRAM 1: Activate pump; DIAGRAM 2: Insert pump
5. Press RESET to clear Total Volume, if desired. set desired flow rate. set drip chamber.

6. Prepare and hang ENTRAFLO Feeding Set


from an IV pole. Close roller clamp.
7. Insert drip chamber into drip chamber brackets. (Diagram 2)
8. Open roller clamp. Expel air from tubing. Close clamp.
9. Stretch silicone tubing around rotor.
Insert pump adaptor into bridge. (Diagram 3)
10. Place tubing into tubing guide. (Diagram 4)
11. Attach pump set to patient’s enteral feeding tube.
12. Open roller clamp.
13. Press RUN/PAUSE to start pump.
14. OFF will turn off the pump at any time. (Flow/Infusion DIAGRAM 3: Assemble DIAGRAM 4: Completely
silicone tubing around rotor. assembled pump set.
Rate, Dose Limit, Volume Delivered and Accumulated
Volume are retained.)

Accumulated Volume
This feature tracks the formula administered over several
feedings when dose limit is used. This feature can be used
to monitor the accumulated total volume of formula over
several intermittent feedings in a day. The total volume of
formula delivered will continue to accumulate until it is cleared.

To View or Clear Accumulated Volume


1. Press RUN/PAUSE to stop pump.
2. Press and hold SET DOSE LIMIT for 5 seconds. The words “TOT VOL”
and the accumulated volume are displayed for 10 seconds.
3. To clear accumulated volume, press RESET within 10 seconds.
4. Press RUN/PAUSE to restart pump.

© 2016 Medline Industries, Inc. EntraFlo is a trademark and Medline is a registered trademark of Medline Industries, Inc. MKT1663349 / e16047 / PDF / 3

You might also like