REP FC
A single component, polymer modified, cement based,
fairing coat Typical Properties
Description
REP FC is a single component, polymer modified, the product Technical information corresponds to the data, which were
which incorporates ground granulated AL. Manaseer technology obtained at 20 °C (±2 °C) temperature and 50+5% relative
plus high quality continuously graded reactive aggregates, humidity.
polymer technology, ready for on-site mixing and use, requiring Appearance : Powder
only the addition of clean water.
Color : Grey
it can be applied by single application from feather edge to 3 mm Mixed density : 1730 kg/m3
thickness. Higher thicknesses can be achieved by applying Layer thickness : 3mm min
multiple layers. 10mm max
Yield : ~ 18.8 liter per 25kg bag.
Uses
Fill a static crack up to 4mm.
Level both vertical and horizontal surfaces. Application Instructions
Improves the aesthetic appearance of concrete surfaces Surface preparation
Suitable for indoor and outdoor applications, in dry and wet The substrate should be sound and clean from dust, oils, dirt,
condition. curing compounds, etc. It should be also sufficiently cured to
avoid any shrinkage cracks. The substrate should be dampened
and excess water to be removed prior to application.
Characteristics / Advantages
Factory controlled pre-blended dry mix which requires
only addition of water.
Excellent workability for easy mixing, and fast
application no independent primer necessary.
Suitable for horizontal, vertical, and overhead
applications
Improved bond to substrate
Excellent freezing resistance.
Provide smooth surface.
Standard Compliance
EN 1504-3 as non-structural repair mortar of class R2
Page 1 of 2
REP FC
Mixing Storage
Pour into a suitable container 7.5-8.0 liters of clean water. Add REP FC has a shelf life of 12 months when stored in its original
25 kg powder to the water and mix using a low speed mixing drill unopened packing in dry conditions. Shelf life may reduce if the
fitted with the suitable mixing paddle. Continue mixing for 2-3 recommended storage conditions changed.
minutes until achieving lumps-free mix.
Safety Instructions
Application
Like any cementitious Product, REP FC contains hydraulic
Apply REP FC as multi coats on a deep crack with uniformly
cement and may cause irritation to skin or eyes. For further
pressing using a flat putty trowel to ensure the entire grouted
information Refer to the Material Safety Data Sheet.
area is filled completely.
Cleaning Disclaimer
Tools should be cleaned immediately with clean water. Manaseer Industrial Complex has the right to amend its
Hardened material should be removed mechanically. datasheets anytime. Please make sure to have the latest
published datasheet version.
Packaging
REP FC is available in 25 kg bags.
This product is environmentally friendly
Manaseer Industrial Complex
Is a Member of US Green Building
Page 2 of 2
Tel: + 962 6 5800600 Fax: + 962 6 5833890 P.O.Box 141414 Amman 11814, Jordan Website: www.manaseer-ic.com Email: [email protected]
Note: All information provided and recommendations made herein are intended to assist customers in determining whether our products are suitable for their applications.
We request that customers inspect and test our products before use in order to make their own final decision regarding suitability. We do not guarantee results, freedom
from patent infringement, or suitability of resultant products for any suggested application with respect to the use of any formula or material described herein.
Ref. Number: REP FC/JO/0807/21
