Instruction
Manual
Micro-pump
Sample electric pump
for release
confined space
Summary
1. Introduction 3
2. Product specifications 4
3. Product description 5
4. Security information 6
5. Operation 7
6. Maintenance 9
7. Warranty 10
2 www.criffer.com
1. Introduction
The Micropump electric sampling pump has been developed for use with gas
detector (mono or multi-gas).
Its main application is transporting potentially dangerous gas samples
(contaminants) from an environment to gas detector sensors
toxic
This product has been developed to be simple and easy to operate, however, its
application involves risks, and to avoid them, it is important to COMPLETE
READING OF THIS MANUAL. Our specialized technical support can help you in
case of doubt.
This manual may suffer changes without prior notice
3 www.criffer.com
2. Product specifications
2.1. General
Power Supply: 2 pilas 1,5v AA batteries
Sampling flow: >400ml/min
Operating temperature: 0 a 50º C
Operating humidity: <90% UR
Wrapping material: ABS
Dimensions: 42 x 27 × 160mm
Approximate weight: 150g (with batteries)
2.2. Features:
Sampling pump, Sampling hose
Cotton filter and instruction manual
4 www.criffer.com
3. Product description
1. On / off button;
5 2. Green Led (On)
6 Indicates that the pump works
8 correctly;
3. Red LED (Fail)
1 Indicates blockage in the air flow;
3 2 4. Connection with the gas detector;
5. Connection to the hose
sampling;
7
6. Sampling hose;
7. Particulate filter;
8. Cotton filter;
4
5 www.criffer.com
4. Security Information
The Micro-Pump sampling pump must be used with batteries
Alkaline, elimination is recommended after the
utilization.
6 www.criffer.com
5. Operation
When using the Micro-Pump sampling pump, follow the following procedures:
5.1. Connect the batteries in the compartment behind the instrument;
5.2. Remove the acrylic tampa from the 5.3. Connect the hose
connection with the hose sample (6) to connector (8);
sample. (5);
7 www.criffer.com
5.4. Connect the gas detector to 5.5. Connect the pump, pressing the
connector (4); button (1) and leave it running for 2
(two) minutes before starting the sampling;
Attention: The minimum sampling time should be 1 (one) minute per meter of
hose connected to the instrument;
8 www.criffer.com
6. Maintenance
When the batteries have a very low charge, the Led On (2) has become weaker,
indicating that they must be replaced.
After use, remove the particles and fibers deposited on the particulate filter (7)
with soft compressed air, clean and dry in the direction
opposite of the pump.
9 www.criffer.com
7. Warranty
This product has 1 (one) year warranty, and may be extended up to (three)
years. See the extended warranty certificate that comes with the product.
10 www.criffer.com
www.criffer.com
Actualizado en 25/05/2018
