SECTION 2 – SYSTEM COMPONENTS SAPPHIRE Total Flood

UL EX4510 Fire Suppression System

PAGE 2-16    REV. 01    2024-JUN-11 (Part No. 451540)

ELECTRICAL ACTUATOR – CONDUIT VERSION

(Part No. 304205030 and 304205040 [GY])
The electrical actuator electrically operates the system’s
master container. The electrical actuator is fitted with an
internal placement switch to provide a fault indication at
the panel if incorrectly fitted. A manual, manual-pneumatic,
pneumatic, or CPM actuator fits on top of the electrical
actuator. The reset tool is attached to the actuator.
Note: If no additional actuator is fitted to the top of the electrical actuator, the
protection cap must remain in place.

Location on system
The electrical actuator is installed to the top of the container
valve.

Figure 2-13
ELECTRICAL ACTUATOR
E001130

Technical specification
Country of origin: US (304205030) System working -20 °C to 50 °C (-4 °F to 122 °F)
China (304205040) temperature range: CE
Body: Mild steel
-18 °C to 54 °C (0 °F to 130 °F)
Body finish: Electroless nickel plate (0.023 mm UL and FM
to 0.028 mm (0.0009 in. to
Life span: 25 years
0.0011 in.)
Factory testing: 100% check on start / finish position
Actuation pin: Stainless steel
Field testing of actuator: Possible
Loose nut: Brass CW603N (CZ124)
Maximum humidity: 80% to 90% RH non-condensing
Nose and JB: Brass CW603N (CZ124)
Ingress Protection class: IP54
Actuation type: Latching
Approvals, listings, and UL, FM, and CE
Reset requirement: Manually with reset tool supplied
certifications:
Connection: 1 in. BSPP (loose nut and manual
Conformity: EN 12094-4 and UL 864A
actuator)
CE certification number: 2831-CPR-S0093
Nominal voltage: 24 VDC
UKCA Certification No.: 0832-UKCA-CPR-S5102
Minimum firing voltage: CE 20.5 VDC Marking requirements: Manufacturer’s mark, Part No.,
UL 864 65% of nominal voltage Serial No., 24 VDC, 0.5 A, CE2831
(15.6 VDC) and UKCA0832
Minimum current: 0.32 A Part number marked on 304205030 (US)
Nominal current: 0.50 A component: 304205040 (China)
Maximum current: 0.54 A Method of marking: Laser or engraved
Maximum monitoring 30 mA Overall size: 132 mm (L) x 73 mm (W)
current: (5.19 in. x 2.87 in.)
Minimum duration of 1s Weight: 1 kg (2.2 lb)
trigger signal: Actuation force / PIN Minimum 66.4 N at 1 mm
Duty: Continuous travel: from unactivated
Manual actuation force: 50 N (11.00 Ibf) Minimum 60.7 N at 2 mm
Nominal pin travel: 4.57 mm (0.18 in.) from unactivated
Electrical connection: 1/2 in. NPT female conduit with Minimum 55.0 N at 3 mm
inbuilt bridge rectifier from unactivated
Back EMF protection: Bridge rectifier Minimum 49.3 N at 4 mm
from unactivated
Placement switch: Integral to unit
Vent area: 31.76 mm² (0.049 in²)
Maximum humidity: 80% to 90% (non-condesning)